ECOLOCITY RL-SC-RSX-RGB-10 Extreme RGB LED Strip Light User Manual
- June 3, 2024
- ECOLOCITY
Table of Contents
RL-SC-RSX-RGB-10 Extreme RGB LED
Strip Light
User Manual
RL-SC-RSX-RGB-10 Extreme RGB LED Strip Light
The top of the connector is marked by
the word “UP”. The polarity of the wires is V1+ on top and V2+ on bottom. If
you need to swap polarity, unscrew alien bolts and flip black connection
wire.
Cut the ribbon on the cut line closest
to your re-connection point.
Use a sharp blade to carefully cut back
the TPU housing 3/8″ without cutting the PC Board.
Unscrew the alien bolts on the
connector, slide in the ribbon completely and tighten the alien bolts.
Test each RGB wire for a secure
connection. If connection does not work switch the polarity.
Once you are certain you have a good connection fill a syringe with the given
silicon gel.
Apply silicon gel to the small hole in
the back of the connector until overflow is seen on the top two holes.
Use gel to gum the commissures between
the ribbon and the connector. We recommend you use gloves and let dry 8 hours.
EcoLightLED.com
OPYRIGHT 2011 ECO LIGHT LED
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>