lumenradio W-BACnet DIN Rail Installation Guide
- September 22, 2024
- LumenRadio
Table of Contents
lumenradio W-BACnet DIN Rail
Specifications
- Product Name: W-BACnet
- Connectivity: Wireless BACnet
- Mounting Options: DIN rail or wall mount
- Gateway Compatibility: LumenRadio device
Product Usage Instructions
Installation
No BACnet cables are needed for installation. Choose either W-BACnet DIN rail
or W-BACnet wall mount.
Gateway Set-Up
Set your Baud rate, stop bit, and parity on the gateway (A or B). Move the
switch to the corresponding setting.
Node Installation
Install the LumenRadio node next to your field devices. Connect the LumenRadio
device with the chosen device (zone controller or room controller).
Optionally, set a local Baud rate.
Connection Status
Observe the lights on your node. When they start blinking green, it indicates
that the node has found the gateway. This process may take up to five minutes.
Gateway Configuration
Move the switch on the gateway to GATEWAY mode. The devices will blink yellow,
indicating they are entering secure mode. This process may take up to 5
minutes.
Wireless Connection
To establish a wireless connection, press the button on the gateway three
times until it blinks blue twice.
App Verification
Verify your installation using the W-BACnet app. For a detailed overview,
select Network Map.
Learn more at www.lumenradio.com
FAQ
Q: How do I know if my node has successfully connected to the gateway?
A: When the lights on the node start blinking green, it indicates a successful
connection to the gateway.
INSTALLATION GUIDE
Connect your building automation system with wireless BACnet
For installation, no BACnet cables are needed.
You need this for installation. Choose either W-BACnet DIN rail or W-BACnet wall mount.
The LumenRadio device next to the BACnet controller (router) can serve as your gateway, with both DIN rail and wall mount options available.
GATEWAY SET-UP
Set your Baud rate, stop bit and parity on the gateway (A or B).
A – Move the switch to ”COMM” or B – Move the switch to . Continue by installing the LumenRadio node next to your field devices, starting with the one closest to your gateway.
Ex. Node to zone controller
Connect the LumenRadio device with chosen device (zone controller). Optionally, set a local Baud rate.
Ex. Node to room controller
Place the LumenRadio device preferably above the chosen device (room controller) and connect. Optionally, set a local Baud rate.
The lights on your node will now sweep in blue.
When the lights start blinking green, the node has found the gateway. This can take up to five minutes.
Go back to the gateway.
A – Move the switch to ”GATEWAY” or B – Move the switch to
The devices blink yellow entering secure mode. This may take up to 5 minutes.
Now you have a wireless connection!
To use the W-BACnet app, press the button on the gateway three times so that it blinks blue twice and you are ready to connect.
Verify your installation in the app.
For a detailed overview, select Network Map.
Learn more at www.lumenradio.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>