DESLOC VIGOPKA 13.56Mhz Smart Lock Installation Guide

DESLOC VIGOPKA 13.56Mhz Smart Lock

Product Information

• Compliance: FCC Part 15
• Operating Conditions: Indoor use
• Radiation Exposure Limit: FCC-compliant
• Distance Requirement: Minimum 20cm from body

Product Usage Instructions

Installation Guidelines:

1. Ensure the door handle is oriented away from the door frame.
2. Position the latch angle to face the door jamb for proper functioning.
3. Follow FCC guidelines for installation to maintain compliance.

Operating Instructions:

1. To open the door, turn the handle away from the door frame.
2. Close the door by pushing it shut until the latch engages with the door jamb.

Maintenance:

1. Regularly check the door handle for any loose screws or components.
2. Keep the area around the door handle clean and free from debris.

Frequently Asked Questions (FAQ)

• Q: What should I do if the door handle feels loose?
  A: If the door handle feels loose, tighten the screws using a screwdriver to secure it in place.

• Q: Can this product be used outdoors?
  A: This product is designed for indoor use only.

Installation Video

Scan to Watch the Video

Parts And Hardware

Overview

PANEL DESCRIPTION

Adjust the backset of the latch

Adjust the backset of the latch (if needed)

• A. Hold the latch in front of the door hole, with the latch face flush against the door edge.
• B. If the latch holes are centered in the door hole, no adjustment is required. Proceed to step 2. If the latch holes are NOT centered, adjust latch. See “Latch Adjustment.”
• C. Latch adjustment (only if needed)

Install latch

Adjust the lock handle direction

Exterior handle direction
The door handle is oriented away from the door frame

Interior handle direction
The door handle is oriented away from the door frame

Install front panel

Connect wire connector

Install back panel

Install batteries and battery cover

Insert the key and test the installation

Install our lock on top (only if needed)

Install our lock on top
If you have a deadbolt lock on top, please move the deadbolt lock to the bottom and install our lock on top to avoid installation issues.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Suppose this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. In that case, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>