ZHIMEIXIN Z6808A 30cm Radio Controlled Bulldozer User Guide
- July 26, 2024
- ZHIMEIXIN
Table of Contents
ITEM NO.: Z6808A RC ENGINEERING
REMOTE CONTROL INFORMATION:
- Frequency: 2.4G
- 25channels
- Remote control distance: 30-40M
- 2x AA type batteries (not included)
BATTERY PERFORMANCE NOTE
For best performance, use alkaline batteries. Battery life will vary according
to brand.
BATTERY SAFETY INFORMATION
-
Don’t mix old and new batteries. Always replace all batteries at the same time.
-
Don’t mix batteries of different types.(Alkaline, standard batteries or rechargeable batteries).
-
Insert the “AA” batteries with their polarity(+/-) as shown inside the battery compartment.
-
Don’t short-circuit terminals.
-
Don’t recharge non-rechargeable batteries. Rechargeable batteries may only be charged under the supervision of an adult.
-
Remove all batteries if vehicle will not be used for a long period of time.
3.7V LITHIUM BATTERY INFORMATION:
• Battery life: 15-20min
• Battery Capacity: 500mah
• Battery charging time: 90-120min
• Charging current and voltage: 5V, 400-450MA -
Dispose of batteries safely. Don’t dispose of batteries in fire as they may explode.
-
Exhausted batteries are to be removed from the toy.
-
Keep these instructions for future reference: they contain important information.
-
Packaging has to be kept since it contains important information.
-
Rechargeable batteries are to be removed from the toy before being charged.
CARE AND MAINTENANCE
- Always remove batteries from the toy when it is not being used for a long period of time.
- Wipe the toy gently with a clean damp cloth.
- Keep the toy away from direct sunlight and/or direct heat.
- Do not submerge the toy into water that can damage the electronic assemblies.
USB CHARGING CABLE INFORMATION:
- Plug in a standard USB power supply
CONTENTS:
- Vehicle and Remote controller
- 3.7V rechargeable Lithium battery
- USB cable
- Water dropper
BATTERY INSTALLATION ON CONTROLLER
REMOTE CONTROL FUNCTION
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>