3M Command Strips Pocket Panel Installation Guide
- July 16, 2024
- 3M Command
Table of Contents
3M Command Strips Pocket Panel
Installation Instructions
-
Affix post-it note with cross lines, at the top center of desired panel location.
-
Remove the thin printed liners from all four 3M Command Strips on the back of panel.
a. Align top center of panel with the post-it, keeping the bottom away from wall.
b. When level, slowly bring panel bottom towards the wall until contact.
Apply pressure on front of panel at 3M Command Strip locations for 30 seconds. -
Install pockets onto panel to accommodate your needs. Use your Pocket Panel until you are satisfied with the layout. If desired, the pockets can then be fixed to the panel.
a. Start by removing the thin plastic liners from either side of a 3M Command Strip.
b. Holding the 3M Command Strip tab, apply light downward pressure on the pocket while pulling the bottom away from the panel, insert the adhesive end behind pocket at bottom center, until the 3M logo aligns with the bottom of the pocket (you may need to create more space behind the pocket if the 3M Command Strip does not insert without touching the pocket).
c. Press the pocket towards the panel, remove tab by pulling downwards.
Repeat procedure for all remaining pockets.
Please Note -The frame pocket does not fix to the panel.
Caution
Do not hang in areas where injury might occur if mounted object fell.
This product has a strong adhesive and may cause damage if removed.
Maximum weight 6.8kg – 15lbs
Designed for indoor use only.
Happy Organizing!
Documents / Resources
| 3M
Command Strips Pocket
Panel
[pdf] Installation Guide
Strips Pocket Panel, Pocket Panel, Panel
---|---