DENY 40715 Door Sweep Instructions
- June 28, 2024
- DENY
Table of Contents
40715 Door Sweep
“`html
Product Information
Specifications:
- Product Name: Door Sweep
- Tools Needed: Hacksaw, scissors, drill
- Material: Metal and vinyl
- Manufacturer Contact: 800.654.8454, MDBUILDINGPRODUCTS.COM
Product Usage Instructions
Installation Steps:
-
Measure the width of the door.
-
Cut the door sweep to the measured length. Use a hacksaw for
metal and scissors for vinyl. -
Close the door and position the door sweep at the inside bottom
with the vinyl seal lightly touching the threshold. -
Drill a 1/8 pilot hole in the center of the holes for
screws. -
Attach the door sweep using the included screws.
-
Before tightening the screws, adjust the sweep so that the seal
rests lightly against the threshold.
FAQ (Frequently Asked Questions)
Q: What should I do if the door sweep is too long after
cutting?
A: If the door sweep is too long after cutting, you can trim it
further with a hacksaw or scissors to fit the door width
correctly.
Q: Can I install the door sweep on an uneven threshold?
A: It is recommended to install the door sweep on a level and
even threshold for proper functionality. If your threshold is
uneven, consider leveling it before installation.
“`
TM
TOOLS NEEDED: HERRAMIENTAS NECESARIAS:
INSTRUCTIONS: 1. Measure width of door and cut
door sweep to length. Cut metal with hacksaw and vinyl with scissors. 2. With
door closed, position door sweep at inside bottom of door with vinyl seal
lightly touching threshold. Drill a 1/8″ pilot hole for screws in center of
holes. 3. Attach door sweep with enclosed screws. Before tightening of screws,
adjust sweep with seal resting lightly against threshold.
INSTRUCCIONES: 1. Mida el ancho de la puerta y
corte la barredora a esa medida. Corte el filete metálico con una segueta y el
vinilo con tijera. 2. Con la puerta cerrada, coloque la barredora en el borde
inferior interior de la puerta con el sello de vinilo tocando el sardinel
levemente. Taladre orificios de 3.2 mm piloto para los tornillos en el centro
de los orificios. 3. Instale la barredora con los tornillos provistos. Antes
de ajustar los tornillos, alínee la barredora con el sello apoyando
ligeramente contra el sardinel.
QUESTIONS? | PREGUNTAS? 800.654.8454 MDBUILDINGPRODUCTS.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>