ovvo Connection System 1240 Instruction Manual

ovvo Connection System 1240 Instruction Manual

OVVO® Connection System 1240 Releasable Specifications

1240 Recommended Minimum Board Depth

Recommended minimum board depth or thickness values for the 1240 will change depending on both the substrate material used as well as the joint angle and axis of connection.
Minimum recommended measurements shown below are categorized according to two distinct groups of board material which share broadly similar connector retention properties.

HPL/Composite, Solid Surface, Hardwoods, Birch Plywood

 | A| B
Fig 1| 16mm| 16mm
Fig 2| 15mm| 15mm
Fig 3| 18mm| 18mm
Fig 4| 18mm| 18mm
Fig 5| 15mm| 28mm
Fig 6| 18mm| 15mm
Fig 7| 18mm| 18mm
Fig 8| 18mm| 18mm
Fig 9| 18mm| 15mm
Fig 10| 18mm| 15mm
Particle/Chipboard, Softwoods/MDF

 | A| B
Fig 1| 18mm| 18mm
Fig 2| 15mm| 15mm
Fig 3| 18mm| 15mm
Fig 4| 18mm| 18mm
Fig 5| 18mm| 28mm
Fig 6| 18mm| 15mm
Fig 7| 18mm| 18mm
Fig 8| 18mm| 18mm
Fig 9| 18mm| 15mm
Fig 10| 18mm| 15mm

These are guidelines only and OVVO ® recommends trial connections be made before going into full production

OVVO® Permanent 1240 Shear & Tensile

The OVVO® Permanent Connection Set is an ideal solution for connecting materials together permanently

Shear

PH1240 (dual test shear)
Chipboard                   = 600 N
MDF                          = 700 N
Beech                         = 1000 N

Tensile

PH1240 (component test tensile) Per Component = 500 N

Milling

(i) Plunge Depth: 12.9mm, +/- 0.5mm
(ii) Travel (Centre to Centre): 39.3mm Out to Out: 51.3mm

CNC Speeds

Plunge:                   2.5 Metres
Travel: 5 Metres –   7.5 Metres
Rotation:               18,000 Revolutions

Speeds vary with different materials

Important! Set Depth Correctly OVVO® 1240 Connection System

IMPORTANT! MAKE A TEST
WICHTIG! MACHEN SIE EINEN TEST
IMPORTANT! FAIRE UN TEST
IMPORTANTE! FARE UN TEST
IMPORTANTE! HACER UNA PRUEBA

RECOMMENDED DEPTH TOLERANCES

1240| 12.9mm, +/- 0.5mm

Set the depth tolerance to 12.9mm and adjust +/- 0.5mm if required

Less than 12.4mm will create an open joint

Greater than 13.4mm connector wing can not lock

Depth Setting Guide OVVO® 1240 Connection System

1. Make a long cut with your tooling. Approximately 200mm long and 12.9mm depth
   

2. Cut in half
   

3. Insert Connection Set and check depth
   

Depth incorrect

Depth correct

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>