CARSON PRO Magnivisor Deluxe CP-60 Instruction Manual
- June 7, 2024
- Carson
Table of Contents
Directions for use:
Inserting / Removing Lens:
- Select desired lens for use.
- Place lens tabs into the holder located under the visor (Fig. 1).
- The flat part of the lens should face inward. The curved portion should face out.
- Press each tab firmly into the holder until you hear each side click into place.
- Simply pull on the lens to remove it from the holder.
Adjusting Head Strap:
- Press on buckle marked “open” to release strap lock (Fig. 2).
- Adjust the strap to the desired size.
- Release buckle to lock the strap in place.
Using Your Magnifier:
- Once placed on your head, the visor can be adjusted up or down as needed.
- Adjust the lens to the desired viewing angle.
- Place an LED lamp in the opening on top of the visor (Fig. 3).
- To activate LED lights, simply push the red button located on top of the lamp.
- Adjust the LED light as needed to illuminate your viewing subject.
- The LED lamp can be adjusted 30 degrees to the right or left and about 90º up or down.
- The LED lamp is removable and can be used as independent light source.
- LED lamp features built-in magnets and can be attached to metal surfaces.
Battery Installation:
- Remove LED lamp from magnifier frame.
- Open battery door located on the bottom of the lamp (Fig. 4).
- Insert batteries according to the polarity diagram printed on the battery door.
- Uses 3 AAA batteries (alkaline batteries are recommended).
- Approximate battery life is 40 – 50 hours.
Cleaning / Care instructions:
- Handle lenses with care to avoid scratching. Always store items in boxes when not in use.
Warning:
Do not look directly at the sun with this product or the naked eye.
Doing so may cause permanent irreversible eye damage.
Important: Clean using a microfiber lens cloth only. Do not use any
abrasives, chemical cleaners, or solvents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>