SLS PI1K2QC0003 K2 Quad Core System User Guide
- June 6, 2024
- SLS
Table of Contents
GettingStarted
K2QC
What’s in the box?
- K2QC Unit
- USB 2.0 A Male-Micro B Male Cable: 1 meter
- HDMI 2.0 Cable Male to Female: 1 foot
- Antenna
- High-Quality Velcro
- GeĘ ng Started with K2QC
- 5V 2A Power Adapter
Starting K2QC
- Connect Micro USB Cable and connect the antenna to K2QC.
- Connect Ethernet Cable to K2QC and another end to Network Device (Hub or Switch or Router).
- Connect HDMI Female to K2QC and HDMI Male end to TV or Projector.
- Connect USB A type Male end of USB Cable to 5V 2A DC power supply to switchboard and switch it ON.
- Android OS starts booĬ ng. Aİ er few seconds, Homepage will appear.
FCCStatement
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This device is acting as a slave and operating in the 2.4 GHz (2412 ~2462 MHz)
band. Ad Hoc function is supported but not able to operate on non-US
frequencies.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment shall be installed and operated with
a minimum distance of 20cm between the radiator & body.
The operation of this device is restricted to indoor use only. (W52 band)
Warning
This radio transmitter [21673-PI1K2QC0003] has been approved by Innovation, Science, and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>