Wuhan Guide Sensmart Tech 3M BTC Bluetooth Remote Controller Instructions
- June 6, 2024
- Wuhan Guide Sensmart Tech
Table of Contents
Wuhan Guide Sensmart Tech
3M BTC Bluetooth Remote Controller
Instructions
Power button:
Long press the power button to start up the Bluetooth remote controller.
Remark: If the Bluetooth remote controller is not connected to the
thermal imager within 3 minutes, it will automatically shut down.
Up button:
After the connection with a thermal imager, all functions of the “Up button” from the thermal imager can be operated.
Menu button:
After the connection with a thermal imager, all functions of the “Menu button” from the thermal imager can be operated.
Down button:
After the connection with a thermal imager, all functions of the “Down button” from the thermal imager can be operated.
Indicator:
Red: It keeps a constant red indicating for a certain while and goes off
if the Bluetooth remote controller is on but not connected with a thermal
imager.
Green: It keeps a constant green indicating for a certain while and goes
off if the Bluetooth remote controller is on and connected with a thermal
imager.
Red flicker: It flickers for a certain while and goes out if the battery
capacity of the Bluetooth remote controller is low.
Installation Methods:
The Bluetooth remote controller is fixed by magic tape, the matte surface is
attached to the fixed point while the hook surface is stuck to the back of the
remote controller, and both the matte and the hook surfaces are affixed and
fixed together.
Wuhan Guide Sensmart Tech Co., Ltd.
http://www.guideir.com
FCC WARNING: This equipment may generate or use radiofrequency energy.
Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. The device has been
evaluated to meet general RF exposure requirements. The device can be used in
portable exposure conditions without restriction.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The rating information is located at the bottom of the unit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>