Bunker360 teXXmo IoT Button User Manual

teXXmo IoT Button
Preliminary User Manual
V0.3

Push – Wait – Release

< 1 sec                                      > 1 sec      > 5 sec         > 10 sec

Release imediately (< 1sec)

protection against accidental push:

1.  Button might flash any color
2.  Button will take no action
3.  Button will not show any further light pattern

Release at blue light (> 1sec)

the pre-defined message will be sent:

1. The button will blink with blue light until done
2. Button will search for closest beacon
3.  The button will connect to WiFi
4. The button will send a message
5.  A button will show reaction…

Release at a red light (> 5sec)

configuration mode will be entered:

1. The button will blink continuously red light
2. The button will appear as an access point
3. Please connect to WiFi with SSID of „IOTButton“ followed by MAC address
4.  The button will show the config menu after 5-7sec in a standard browser, if not… connect to „http://192.168.4.1“
5.  The button will shut down and stop blinking after 2min, if no connection is established

Configuration Mode (connection at 192.1678.4.1)

Release at a green light (> 10sec)

STA mode will be entered:

1. The button will blink continuously green light
2.  The button will be the device of pre-defined WiFi
3. Please connect „http://iotbutton“
4. Button will show config menu
5. Button will shut down and stop blinking after 2min, if no connection is established

teXXmo IoT Button

§.15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
   (2) this device must accept any interference received, including interference that may cause undesired operation.
   §15.21
   Changes or modifications made to this equipment not expressly approved by bunker360 LLC, Miami, FL, USA
   may void the FCC authorization to operate this equipment.
   §15.105
   Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
   one or more of the following measures:
   — Reorient or relocate the receiving antenna.
   — Increase the separation between the equipment and receiver.
   — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
   — Consult the dealer or an experienced radio/TV technician for help.

teXXmo IoT Button
get in touch:
www.iot-button.eu
info@iot-button.eu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>