CAR015639 Connected Base Card for Portalp RS Drives Instructions
- June 6, 2024
- PORTALP
Table of Contents
PORTAL declares that :
• DIVA5-DIVA L3-TINA2-ISO3 operators comply with the prescriptions of the
European directives
EMC: directive 2014/30/UE
Machines: directive 2006/42/CE
• PortalpRS range operators comply with the prescriptions of the European
directives
Radio: directive 2014/53/UE
Machines: directive 2006/42/CE
For this, the installation rules described in the installation manual must be
respected. The operator must be installed according to the national rules of
each country. Pierrick Campion, Technical Director The complete declaration of
conformity and declaration of incorporation are available from our
distributor.
Important safety instructions
EMERGENCY EXIT DOORS ACCORDING TO EN 16005
In emergency exit, CLOSE mode deactivates the emergency exit function. It is
absolutely mandatory to verify that nobody is still inside the building before
using this mode.
Emergency exit slidings doors execute a test when they are in automatic
mode:
- to the power supply
- after reset
- every 24 hours
MONITORING THE DOORS
Staff should be trained to use automatic doors for:
- Informing parents and their children about the risks associated with moving doors, and ensuring that children are not exposed to unnecessary risks
- Help and advise elderly, infirm, and disabled persons
- Acting appropriately in the event of an emergency
WARNING :
Important Safety Instructions. It is important for the safety of persons to follow these instructions. Keep these instructions.
- Do not use if repair or adjustment is necessary
- Disconnect the power supply during cleaning or other maintenance operation
- Lack of maintenance may influence the safety of users, make you liable for prosecution and void the manufacturer’s guarantee.
- Intervention on the door must be done by PORTAL approved companies and technicians
- When using manual and/or remote controls, be sure that you have an open view of the door, people stay away from the door and warn them
SAFETY FUNCTIONS
- In case of an opening obstacle, the door will stop then close again
- In case of a closing obstacle, the door will re-open
- In case of opening safety device activation, the door can slowly open
- In case of closing safety device activation, the door will re-open
- In case of fault, the door can do a safety movement or enter in manual mode without any command or mode change.
FORBIDDEN USES
-
Do not run out the door when it is closing
-
Do not let any object constituting an obstacle to the movement of the leaves
-
Do not try to open the cover to access inside the operator
-
Do not tamper with the safety devices
-
Do not touch the leaves during the functioning
-
Do not use the guard mode to let people pass
through the door (sliding doors) -
Do not let children play with the fixed control devices.
-
Put the remote control devices out of reach of children
Restrictive use: indoor use only
The frequency band for BLE: 2400-2483.5MHz
Max power : 10mW max. (EIRP)
FCC Part 15 compliance statement
PORTALP RS BASE CARD (CAR 015639)
FCC ID: 2AYPKCAR015639
IC: 26874-CAR015639
Model / HVIN: CAR 015639
All changes or modifications not expressly approved by PORTAL could void the
user’s authority to operate the equipment. This device complies with part 15
of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Representative in the USA :
PORTAL USA, INC
16170 Lee Rd, Suite 100
Fort Myers, FL 33912
IC REQUIREMENTS (Canada)
This class (B) digital apparatus complies with Canadian ICES-003
LICENCE-EXEMPT RADIO APPARATUS (ISED)
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RADIO FREQUENCY (RF) EXPOSURE COMPLIANCE OF RADIOCOMMUNICATION FOR MOBILE APPARATUS
To satisfy FCC and IC RF Exposure requirements for mobile devices, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer to this distance is not recommended. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PORTAL reserves the right to change the presented products and materials
without
prior notice. Their description – under any circumstances – cannot take a
legal aspect.
The data contained in this document are the property of PORTAL and
should not be changed without the prior agreement of the manufacturer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>