DIEFFEMATIC MFE Photo Sensor with Reflector User Manual

June 6, 2024
DIEFFEMATIC

DIEFFEMATIC - LOGO MFE Photo Sensor with Reflector
User Manual
DIEFFEMATIC MFE Photo Sensor with
Reflector

TECHNICAL CHARACTERISTICS

• Power supply AC 12/24V – DC 12/24/36V
•Consumption 100mA
•Distance 12 meters
•Working Temperature -25°C – *65°C
•Relay Capacity “Volt-free contacts”
•Protection grade IP54
•Polarization filter This feature prevents reflections caused by reflective

objects.

LEDs

Red Orange Green Signal strength
No signal
Low
Medium
High

OPEN THE PHOTOCELL

DIEFFEMATIC MFE Photo Sensor with Reflector - OPEN THE
PHOTOCELL| DIEFFEMATIC MFE
Photo Sensor with Reflector - OPEN THE PHOTOCELL 2| DIEFFEMATIC MFE Photo Sensor with Reflector - OPEN
THE PHOTOCELL 3
---|---|---
01 • Press the chrome part in the areas indicated in the image.| 02 • Slide the chrome part| 03 • Open the photocell by separating the pieces from the bottom part.

INSTALLING THE PHOTOCELL

DIEFFEMATIC MFE Photo Sensor with Reflector - INSTALLING THE
PHOTOCELL

FIXING THE PHOTOCELL

DIEFFEMATIC MFE Photo Sensor with Reflector - FIXING THE
PHOTOCELL

  1. • Place the photocell base in the desired location so that the power cable passes through the hole in the base.
  2. • Mark the location of the 3 fixing holes and drill the holes.
  3. • Secure the photocell with suitable bushings and screws.
  4. • Connect the wires to the circuit board (wiring diagram image).
  5. • Turn on the photocell without placing the photocell cover.

MIRROR PLACEMENT

DIEFFEMATIC MFE Photo Sensor with Reflector - MIRROR
PLACEMENT

  1. • Place the mirror in front of the photocell, with the help of the light from the photocell.
  2. • Make use of the indicator lights to set the best location for fixing the mirror.
  3. • Mark the location of the fixing hole and drill.
  4. • Secure the mirror with the appropriate bushing and screw.

PHOTOCELL TUNING

DIEFFEMATIC MFE Photo Sensor with Reflector - PHOTOCELL
TUNING

  1. • If there is no signal, or if the signal is low, use the tuning screws to adjust the direction of the light to increase the signal.

WIRING DIAGRAM

DIEFFEMATIC MFE Photo Sensor with Reflector - WIRING
DIAGRAM

The MFE is designed to protect against any light disturbance. However, too much light can cause unstable conditions with the sensor, such as; strong sunlight directed or reflected exactly in the sensor’s field of view. It is recommended to avoid such installation.
The existence of ice, snow, fog, or smoke can interfere with the operation of the photocell

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals