ASUS ZS590KS ZenFone Dual Sim 8GB RAM 12GB G5 Smart Phone User Guide

ZS590KS ZenFone Dual Sim 8GB RAM
12GB G5 Smart Phone
User Guide
E18136

First Edition / April 2021
Model: ASUS_I006D (ZS590KS)
Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device.
NOTE: For the complete E-Manual and more detailed information, refer to https://www.asus.com/support/.

Front features

Side and rear features

Charging your ASUS Phone

To charge your ASUS Phone:

1. Connect the USB connector into the power adapter’s USB port.
2. Connect the other end of the USB cable to your ASUS Phone.
3. Plug the power adapter into a wall socket.
   

IMPORTANT!

• When using your ASUS Phone while it is plugged into a power outlet, the grounded power outlet must be near to the unit and easily accessible.
• When charging your ASUS Phone through your computer, ensure that you plug the USB cable into your computer’s USB port.
• Avoid charging your ASUS Phone in an environment with an ambient temperature of above 35ºC (95ºF).

NOTES:

• For safety purposes, use ONLY the bundled power adapter and cable to avoid damaging your device and prevent the risk of injury.
•  For safety purposes, use ONLY the bundled power adapter and cable to charge your ASUS Phone.
• The input voltage range between the wall outlet and this adapter is AC 100V – 240V. The output voltage of the AC power adapter for this device is +5V- 10V 3A, 30W.

Installing a Nano SIM card

To install a Nano SIM card:

1. Push the bundled eject pin into the hole on the card slot to eject the tray out.
2. Insert the Nano SIM card(s) into the card slot(s).
3. Push the tray to close it

NOTES:

• Both Nano SIM card slots support GSM/GPRS/EDGE, WCDMA/HSPA+/DC-HSPA+, FDD-LTE, TD-LTE, and 5G NR Sub-6 network bands. Both  Nano-SIM cards can connect to VoLTE (4G Calling) service. But only one can connect to 5G NR Sub-6 data service at a time.
• Actual network and frequency band usage depends on network deployment in your area. Contact your telecom carrier if 5G NR Sub-6 support and VoLTE  (4G Calling) service are available in your area.

CAUTION!

• Do not use sharp tools or solvents on your device to avoid scratches on it.
• Use only a standard Nano SIM card on your ASUS Phone.

Using NFC

NOTE: NFC is only available in selected regions/countries.
You can use NFC in the following two scenarios:
Reader mode: Your phone reads information from a contactless card, NFC tag, or other NFC devices. Place the NFC area of your phone on the contactless card, NFC tag, or NFC device. 

Card Emulation mode: Your phone can be used as a contactless card.
Place the NFC area of your phone on the NFC area of the NFC reader.

Federal Communications Commission Statement

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which  can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following  measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  The antenna(s) used for this transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all WiFi products that are marketed in US must be fixed to US-operated channels only.
The responsible party within the USA per 47 CFR Part 2.1077(a)(3):
ASUS COMPUTER INTERNATIONAL (America)
Address: 48720 Kato Rd., Fremont, CA 94538, USA
Telephone: +1-510-739-3777

RF Exposure Information (SAR)

This device has been tested and meets applicable limits for Radio Frequency (RF) exposure.
Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.6 Watts per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of the European Union limit. Tests for SAR are conducted using standard operating positions with the device transmitting at its highest certified power level in all tested frequency bands.
To reduce exposure to RF energy, use a hands-free accessory or other similar option to keep this device away from your head and body. Carry this device at least 15 mm away from your body to ensure exposure levels remain at or below the as-tested levels. Choose the belt clips, holsters, or other similar body- worn accessories which do not contain metallic components to support operation in this manner. Cases with metal parts may change the RF performance of the device, including its compliance with RF exposure guidelines, in a manner that has not been tested or certified, and use of such accessories should be avoided.

The highest FCC SAR values for the device (ASUS_I006D) are as follows:

• 1.18 W/Kg @1g (Head)
• 1.15 W/Kg @1g (Body)

The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure uidelines.
SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC
ID: MSQI006D.

Canada, Industry Canada (IC) Notices

This device complies with Industry Canada’s license-exempt RSS standard(s).
Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

This device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite
systems.

Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits. The Wireless Device should be used in such a manner that the potential for human contact during normal operation is minimized. This device (ASUS_I006D) has been evaluated for and shown compliant with the IC Specific Absorption Rate (“SAR”) limits when installed in specific host products operated in portable exposure conditions.
Additional Canadian information on RF exposure also can be found at the following web address: http://www.ic.gc.ca/eic/site/smt- gst.nsf/eng/sf08792.html.

This equipment should be installed and operated with a minimum distance of 15 mm between the radiator and your body.

CAN ICES-003(B)/NMB-003(B)
This Class B digital apparatus complies with Canadian ICES-003.
This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter, except tested built-in radios.
The County Code Selection feature is disabled for products that are marketed in the US/ Canada.
The IC ID for this device (ASUS_I006D) is 3568A-I006D.

Prevention of Hearing Loss

To prevent possible hearing damage, do not listen at high volume levels for long periods.

For France, headphones/earphones for this device are compliant with the sound pressure level requirement laid down in the applicable EN  503321:2013 and/or EN50332-2:2013 standard required by French Article L.5232-1.

Using GPS (Global Positioning System) on your ASUS Phone

To use the GPS positioning feature on your ASUS Phone:

• Ensure that your device is connected to the Internet before using Google Map or any GPS-enabled apps.
• For first-time use of a GPS-enabled app on your device, ensure that you are outdoors to get the best positioning data.
• When using a GPS-enabled app on your device inside a vehicle, the metallic component of the car window and other electronic devices might affect the GPS performance.

Safety information

CAUTION! Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

ASUS Phone care

• Use your ASUS Phone in an environment with ambient temperatures between 0 °C (32 °F) and 35 °C (95 °F).

The battery
WARNING: Disassembling the battery by yourself will void its warranty and may cause serious harm.

Your ASUS Phone is equipped with a high-performance non-detachable Li-polymer battery. Observe the maintenance guidelines for longer battery life.

• Do not remove the non-detachable li-polymer battery as this will void the warranty.
• Avoid charging in extremely high or low temperatures. The battery performs optimally in an ambient temperature of +5 °C to +35 °C.
• Do not remove and replace the battery with a non-approved battery.
• Use only ASUS battery. Using a different battery may cause physical harm/injury and may damage your device.
• Do not remove and soak the battery in water or any other liquid.
• Never try to open the battery as it contains substances that might be harmful if swallowed or allowed to come into contact with unprotected skin.
• Do not remove and short-circuit the battery, as it may overheat and cause a fire. Keep it away from jewelry or metal objects.
• Do not remove and dispose of the battery in fire. It could explode and release harmful substances into the environment.
• Do not remove and dispose of the battery with your regular household waste. Take it to a hazardous material collection point.
• Do not touch the battery terminals.
• To avoid fire or burns, do not disassemble, bend, crush, or puncture the battery.

NOTES:

• Risk of explosion if the battery is replaced by an incorrect type.
• Dispose of used battery according to the instructions.

The charger

• Use only the charger supplied with your ASUS Phone.
• Never pull the charger cord to disconnect it from the power socket. Pull the charger itself.

Caution
Your ASUS Phone is a high-quality piece of equipment. Before operating, read all instructions and cautionary markings on the AC Adapter.

• Do not use the ASUS Phone in an extreme environment where high temperature or high humidity exists. The ASUS Phone performs optimally in an ambient temperature between 0 °C (32°F) and 35 °C (95 °F).
• Do not disassemble the ASUS Phone or its accessories. If service or repair is required, return the unit to an authorized service center. If the unit is  disassembled, a risk of electric shock or fire may result.
• Do not short-circuit the battery terminals with metal items.

Operator access with a tool

If a TOOL is necessary to gain access to an OPERATOR ACCESS AREA, either all other compartments within that area containing a hazard shall be  inaccessible to the OPERATOR by the use of the same TOOL, or such compartments shall be marked to discourage OPERATOR access.

ASUS Recycling/Takeback Services

ASUS recycling and takeback programs come from our commitment to the highest standards for protecting our environment. We believe in providing solutions for you to be able to responsibly recycle our products, batteries, other components as well as packaging materials. Please go to
http://csr.asus.com/english/Takeback.htm for detailed recycling information in different regions.

General Usage (typical body-worn) (for Japan)
This device (front & rear side) should be operated under a separation distance of 15 mm or more from the human body.

• The other four sides are not in close proximity to the human body at the general use as described above.

Proper disposal

| Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
---|---
| DO NOT throw the battery in municipal waste. The symbol of the crossed-out wheeled bin indicates that the battery should not be placed in municipal waste.
| DO NOT throw this product in municipal waste. This product has been designed to enable proper reuse of parts and recycling. The symbol of the crossed-out wheeled bin indicates that the product (electrical, electronic equipment, and mercury-containing button cell battery) should not be placed in municipal waste.
Check local regulations for disposal of electronic products.
| DO NOT throw this product in fire. DO NOT short circuit the contacts. DO NOT disassemble this product.

WARNING
Cancer and Reproductive Harm- www.P65Warnings.ca.gov

NOTE: For more legal and e-labeling information, check on your device from Settings > System > Regulatory labels and Settings > System > About Phone>  Legal Information.

FCC COMPLIANCE INFORMATION
Per FCC Part 2 Section 2.1077

Responsible Party: Asus Computer International
Address: 48720 Kato Rd, Fremont, CA 94538.
Phone/Fax No: (510)739-3777/(510)608-4555
hereby declares that the product
Product Name: ASUS Phone
Model Number: ASUS_I006D

compliance statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ASUS
Address: 1F., No.15 Lide Rd., Beitou Dist., Taipei
City 112, Taiwan
Tel: 886228943447
Fax: 886228907698
Declaration

We declare that the IMEI codes for this product, ASUS Phone, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and it complies with the relevant IMEI integrity related requirements expressed in the GSM standards.
Should you have any questions or comments regarding this matter, please contact us.

Sincerely yours,
ASUSTeK COMPUTER INC.
Tel: 886228943447
Fax: 886228907698
Support: https://www.asus.com/support/

Copyright © 2021 ASUSTeK COMPUTER INC.
All Rights Reserved.
You acknowledge that all rights of this Manual remain with ASUS.
Any and all rights, including without limitation, in the Manual or website, and shall remain the exclusive property of ASUS and/or its licensors. Nothing in this  Manual intends to transfer any such rights or to vest any such rights to you.
ASUS PROVIDES THIS MANUAL “AS IS” WITHOUT A WARRANTY OF ANY KIND. SPECIFICATIONS AND INFORMATION CONTAINED IN  THIS MANUAL ARE FURNISHED FOR INFORMATIONAL USE ONLY, ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT NOTICE,  AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY ASUS.
ZenTalk Fans Forum
(http://www.asus.com/zentalk/global_forward.php)

http://www.asus.com/zentalk/global_forward.php

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>