Aaeon Technology ITS-GW01 Industrial And Embedded Computing Platforms Installation Guide
- June 6, 2024
- Aaeon Technology
Table of Contents
ITS-GW01
Quick Startup Guide
Step 1: Connect the Hardware
i. Connect the power adapter to the system (5V@3A5.5/2.1mm DC) and plug the
system in.
ii. Connect to a display by plugging a VGA connector into the port on the
system. Ensure the other end of the VGA cable is plugged into the display
properly.
iii. Connect your keyboard and mouse to the system.
(Note: Ensure everything is connected properly and securely.)
Step 2: Prepare Drive
i. Prepare the bootable drive with the OS (Linux).
Step 3: Turn On
i. Turn on the system power and install the OS and drivers.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Caution:
To assure continued FCC compliance:
- Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Regulatory Information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body. 5150-5250MHz is limited to use indoors only.
This radio transmitter (identify the device by certification number or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna information:
Antenna| Antenna Type| Frequency range| Antenna Gain
vaule(dBi)
---|---|---|---
RFA-LTE-T42-U-M62-1| EC25AFXGA 4G LTE module| 698-960MHz| 0.9 dBi
1710-2170 MHz| 2.5 dBi
2300-2700 MHz| 3 dBi