Shenzhen Zijieyuanzi Technology S2068 Sleep Headphones Bluetooth Headband For Side Sleepers User Guide
- June 6, 2024
- Shenzhen Zijieyuanzi Technology
Table of Contents
Shenzhen Zijieyuanzi Technology S2068 Sleep Headphones Bluetooth
Headband For Side Sleepers Pairing Sleepband to phone for the first time
- Hold “-” button for ls, the Sleepband will power on and enter pairing mode.
- Open Bluetooth on your device and select “Sleepband”. Headphones are now paired to your device successfully
Pairing Sleepband to phone after pairing successfully once
How to Charge Sleepband
Charging Time: Full charge: about 1-2 hour
Note: Please do not charge higher than 5V/2A, doing so may damage the
Headphones.
Package Contents
- Sleepband: xl
- Charging Cable : xl
- Eartips: x4
- User Manual : xl
Warning: If an ear tip becomes lodged in your ear, seek skilled medical assistance to remove the ear tip. Damage to the ear may be caused by non- professionals attempting to remove the ear tip.
How to wear Sleepband correctly
How to clean the headband?
Please take out the Bluetooth module first, and then wash the headband at
20″C-40’C / 68’F-104’F.
How to take out/ install the Bluetooth module?
www.gonovate.com/sleepband-install/
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>