JIARUIXIN JR1602FCC Remote Controller User Manual
- June 6, 2024
- JIARUIXIN
Table of Contents
Remote Controller
User Manual
- Supply Voltage: DC 3.0V, Battery: 2*1.5V AAA (not included)
- Frequency 2.407GHz-2.473GHz (Peak output power: 5dBm)
- Instructions
-
To connect the remote controller to the car, turn off the switch on the car first.
-
Hold down “▲” and “▼” simultaneously for 3 seconds until the light indicator flashes.
-
Turn on the switch on car, the light stops flashing. The remote controller is now paired and ready to use.
-
The remote controller enters standby mode after 10 seconds of inactivity. Press any button to wake it up.
-
Speed Button
Press “S” to operate the bulldozer move in slow, medium, high speed.
1 light is low speed, 2 lights mean medium speed, 3 lights mean high speed.
When driving backwards, the car can only run in low speed. -
Brake Button
Press “P” once to hold the brake, all lights flash. Press it again to release the brake.
※ The remote controller only can be used under adult’s guidance.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna;
- Increase the separation between the equipment and receiver;
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
- Consult the dealer or an experienced radio/TV technician for help.
Warning:
Changes or modifications to this unit not expressly approved by the part
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>