CARSON LH-50 10x LED Lighted Focusing Loupe Instruction Manual
- June 6, 2024
- Carson
Table of Contents
CARSON LH-50 10x LED Lighted Focusing Loupe
Instructions for Use
Installing the Battery
Turn loupe over and locate the battery cover inside acrylic base. Unscrew cover and remove as shown below. Install one CR2032 coin cell battery with the correct polarity. Reattach battery door and secure with screw.
NOTE: Battery may be difficult to remove by hand. Needle nose pliers are
recommended.
WARNING: INSPECT ALL BATTERIES FOR SIGNS OF CORROSION OR LEAKAGE. DO NOT EXPOSE TO FIRE OR EXCESSIVE HEAT. USE ALKALINE BATTERIES ONLY, RECHARGEABLE BATTERIES NOT RECOMMENDED. INSERT ALL BATTERIES IN THE DIRECTION
Activating LED
Light Slide switch to turn on/off LED. INDICATED.
Focusing Loupe
Place loupe over viewing subject and turn focusing ring until image is sharp.
Cleaning Your Magnifier
Clean lens with a soft, clean microfiber cloth by rubbing gently in a circular
motion. Moisten the lens cloth with water if necessary. Do not use harsh
chemicals, solvents or abrasives as they may damage the lens.
FIRE HAZARD: KEEP MAGNIFIER AWAY FROM DIRECT SUNLIGHT TO PREVENT ACCIDENTAL
FIRE.
CAUTION: VIEWING THE SUN CAN CAUSE PERMANENT EYE DAMAGE. DO NOT VIEW THE SUN WITH THIS ITEM. DO NOT PLACE THE LED LIGHTS DIRECTLY ON YOUR EYE AS THIS MAY CAUSE DAMAGE AS WELL.
Customer Service
If you experience any difficulties, please contact us and we will be happy to help you.
-
In the U.S.A.
Phone: 1-631-963-5000
Email: info@carson.com -
In the U.K.
Phone: +44 (0) 1938 557440
Email: uksupport@carson.com -
In the E.U.
Phone: +44 (0) 1938 557440
Email: eusupport@carson.com
For warranty information, visit www.carson.com/warranty
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>