DS18 LED-BTC LED Bluetooth Control User Manual
- June 6, 2024
- DS18
Table of Contents
LE D-BTC
RGB LED CONTROL
WATERPROOF BT 4.0
- CUSTOMIZABLE COLORS
- BRIGHTNESS
- SPEED
- PLAYABLE MUSIC CONTROL CAPABILITY
- LONGER RANGE
- ON/OFF APP SWITCH
COMPATIBLE WITH:
ROB LED CONTROL
- UNIVERSAL BT 4.0
- 5 AMP LIGHTING CAPACITY
- LONGER RANGE
- WATERPROOF IP65 RATED
The LED-BTC is an app-based, BT solution for RGB LED lighting control. The applications are truly limitless lending to all types of environments whether wet or dry.
FEATURES:
- BT 4.0 (Faster speed and up to 150 ft. range*)
- 5 Amps of lighting capacity
- Control multiple LED light
- Waterproof – 1P65 Rated
- 12 VOLT applications
- Not for submersible use
- iOS – connect up to 7 controllers
- Android – connect up to 4 controllers
- Compatible with Android and iPhone
- Turn App On/Off to show or hide on Bluetooth deuices
. *Depends on the conditions.
WE LIKE IT LOUD
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is
applicable to only mobile configurations. The antennas used for this
transmitter must be installed to provide a separation distance of at least
20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>