DUOMO Aranet4 Home Sensor User Guide
- June 6, 2024
- DUOMO
Table of Contents
DUOMO Aranet4 Home Sensor
**The Aranet4 sensor screen explained
**
How to pair Aranet4 to my smart device
Connect your smartphone with the Aranet4 device via Bluetooth by using iOS or Android app to:
- Access real-time measurement data overview
- View seven-day measurement history
- Set alarms and frequency of sensor readings
- View atmospheric pressure monitoring
- Access all nearby Aranet4 devices
- Do the CO2 calibration of the device
- Get access to the available firmware updates
The Aranet4 device can be connected to a smart device using the Bluetooth
connection and the Aranet4 app on either iPhone or Android.
Make sure Bluetooth connectivity is enabled on your smart device and on your
Aranet4 device.
To connect your Aranet4 to your smart device with the following steps:
-
Launch the Aranet4 app and on the main page (My devices) add a new device by clicking on the (+) symbol.
-
Select your Aranet4 device from the list.
-
When prompted, confirm the start of pairing.
-
Type in the 6 digit passcode that is shown on the display of your Aranet4 device.
-
View 7-day history
-
Set alarms and sensor reading frequency
-
View atmospheric pressure monitoring
CO2 LEVELS
- 420 ppm – Fresh outdoor air
- 420-800 – Optimal air quality indoors
- Good normal level (below 1000 ppm)
- Average level (1000 to 1400 ppm) brain cognitive functions decrease by 15%
- Unhealthy high level (above 1400 ppm) brain cognitive functions decrease by 50%
Configuration
Configuration switches are located under the battery cover on the back of the device. While batteries remain inserted, adjust the switch position (up or down) using the pin tool that is supplied with the Aranet4 device. Switches can be adjusted while batteries are removed as well, but note that if you remove the batteries, the measurement history will be erased from Aranet4 memory. The changed preference setting will be enabled once the batteries are inserted back in.
AUTO / MANUAL
CO2 calibration mode to either manual (default position) or automatic mode.
(See user manual) °C / °F – Celsius or Fahrenheit degrees.
Bluetooth – Enable or disable
Aranet radio / 0* (PRO version) – enable or disable (0) the Aranet radio
connectivity. Refer to chapter Using Aranet4 device with the Aranet PRO base
station.
To see a detailed user manual and screen explanation visit aranet4. com or
scan this QR code
Aranet 4 does not impact resistant Do not use in high humidity environments (RH 85% +) Do not leave the device in direct sunlight
Connect your smartphone with the Aranet4 app to
Duomo (UK) Ltd | 01905 797989 | [email protected]