Sailsky Electronic MU03026 Wireless Gaming Speaker Instruction Manual

Sailsky Electronic MU03026 Wireless Gaming Speaker Instruction Manual

Content

• Bluetooth speaker x 1
• Charging cable x1
• Instruction Manual x 1

Product Specification

• Lighting: 8 x color changing LEDs
• Battery Capacity: 1200 mAh/3.7V
• Play Time: around 3 Hours (Different environmental conditions will affect play time duration)
• Charging Time: around 3 Hours
• Speaker Output: 3W x 2
• Range: 33ft / 10 m
• Frequency Response: 20Hz-20KHz
• Operating temperature range: 0-45 C Includes 11.81” Micro USB charging cable
• Dimension: 11.8″ X 2.56″ X 2.17″
• Weight: 325g
• Input: DC 500mA

Part Name

1. Volume Down / Previous Song
2.  Power key
3. Volume Up / Next Song
4. Light switch
5. LED Indicator
6. Charging Po

How To Use

• Power on : Press the power key 2 seconds when it is off. The blue LED light will be on, and a voice will prompt, this indicates the BT Speaker is in pairing mode.
• Pairing: Activate the Bluetooth function on your phone within range and select “Gaming Speaker” from the list shown. When the blue LED light stops flashing, it has paired successfully and you will hear a tone. The blue LED will flash slowly when playing music.
• Play/Pause : When it is playing, press the center key to pause, then press the center key  again to play.
• Volume up : Hold down to increase the volume.
• Volume down : Hold down to decrease the volume.
• Previous song : Press the once to play the previous song.
• Next song : Press the once to play the next song.
• Power off : When the speaker is standby or operating, press and hold the speaker key 3 seconds to shut down the speaker.
• Light up : Toggle the light switch to turn the multi-color changing LEDs off/on.
• Low Battery : LED indicator turns off and a short tone will prompt

To Charge:

1. Insert the USB connector end of the included cable (see packing list) into the USB jack on the charger or USB port on the computer.
2. The indicator light will be red while charging.
3. When the speaker is fully charged, the indicator light will turn off. Please unplug your charger from the power source.
4. Please use a qualified charger to recharge your speaker, otherwise it may result in damage or even explosion.
5. Repeated charging and discharging of the speaker will lead to decreased battery life over time, which is normal for rechargeable batteries.
6. You must charge the Bluetooth speaker if it has not been used for more than 6 months.

WARNING

• Charge and operate only as indicated in this manual, as improper use may result in damage to the product or injury.
• To avoid risk of shock or injury, do not dismantle the device or insert any objects into the speaker.
• To avoid electronic interference and/or compatible conflicts, turn off the product in any facilities where posted notices instruct you to do so.
• Do not pull the speaker charging cable. Damage may result to the cable.
• Keep out of reach of children. This is not a toy.
• Avoid exposure to moisture, liquids, heat, flame and high voltage equipment.
• Retain these instructions as they contain important information.
• Do not short circuit the input terminals of the speaker.
• Do not drop, place heavy weight or allow heavy impact to the speaker.
• PCB of battery should not be crushed and twisted.
• Battery body should not be bended.
• Do not disassemble and Do not dispose of in fire.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement

Tips: Please do not turn the volume knob to the maximum level to prevent hearing damage and to prolong the service life of the system.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and
(2) this device must accept any interference received including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.”

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.”

FCC ID: 2AYB6-MU03026

Distributed By: 1616 Holdings, Inc
701 Market Street, Suite 200,
PhiIadeIphia, PA 19106
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>