Accuride FGUARD-EL1 FridgiGuard Electronic Lock for Refrigerators User Manual
- June 6, 2024
- ACCURIDE
Table of Contents
**Accuride FGUARD-EL1 FridgiGuard Electronic Lock for Refrigerators User Manual
**
Instructions
Step 1. Swipe your FridgiGuard RFID card to unlock. The LED will turn to red after open the lock. Make sure your card is authorized before you swipe it. Refer our software user manual to authorize your card.
Step 2. The lock will begin to alarm after the set opening time is exceeded. Refer our software user manual to set the opening time.
Step 3. The alarm will stop after the door is closed and locked. The LED will resume to green.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter.”