Otodata Wireless Network X 2R0 TAG-X Transceiver User Guide
- June 6, 2024
- Otodata Wireless Network
Table of Contents
Otodata Wireless Network X 2R0 TAG-X Transceiver
USER GUIDE
- Reinforced
- Completely water tight
- Long service life
- Highly robust communication protocol
- Easy to install
The TAG X 2R0 Transceiver is an autonomous transceiver that is used primarily for the identification, control and management of assets using RF (radio frequencies). The TAGs may be used in conjunction with active base station receivers. The tag may be affixed to assets in order to perform data collection.
Description of the system
The TAG system has been developped with the goal of providing the following services.
- Data transfer, logging and Telemetrie
- Temperature monitoring
- Humidity monitoring
- Automated inventory management
- Automated fleet management
TAG Trancsceiver Installation guidelines
The TAGs must be installed by qualified personnel.
The housing must be affixed to a solid surface using materials that will
prevent rattles and or (fall-off) . The entire mating surface must be used in
order to ensure a solid installation.
The housing must be installed on surfaces that will not rust over time.
Using the TAG transceiver
PRIOR to initialization ensure that tags are installed according to
installation guidelines. Upon initialisation the tags will register on the
network and create a secure connection. This is an automated process and
requires no interaction.
REMOTE (Re-start / Re-initialization)
The Re-start function is used primarily as a preventative measure. A clean Re-
start is required in order to flush all of the system buffers. The Re-
initialization function is used in order to re-name and change a tag ID.
WARNINGS
- This equipement may only be used and serviced by authorized personnel
- Follow all applicable regulatory and safety guidelines when choosing a location
- Do not install the tag on semi-rigid surfaces
- Do not install the tag on moving structures
- Do not tamper with or modify the tag enclosure under any circumstances.
- This equipment must be professionally installed.
- The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 22 cm from the radiating element to any nearby persons.
- This device and its antenna must not be co-located or operated in conjunction with any other antenna or transmitter.”
- The cell in the tag enclosure in not user-replaceable and non-rechargeable.
IC and FCC warning statements:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
The information contained in this document is subject to change without notice and is proprietary to Otodata Wireless Networks Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>