kuando BUSYLIGHT 1582 Busylight with USB Power Adaptor User Guide
- June 6, 2024
- kuando BUSYLIGHT
Table of Contents
kuando BUSYLIGHT 1582 Busylight with USB Power Adaptor
IN THE BOX
- 1 pcs Flowscape Busylight
- 1 pcs USB Power Adaptor
- 1 pcs Adhesive tape for mounting
MOUNTING THE PRODUCT FOR DESK STATUS PURPOSE
Please use the adhesive tape to mount the Flowscape Busylight.
Please consider standardized placement and visibility in the open office
environment.
MOUNTING THE PRODUCT FOR ROOM STATUS PURPOSE
Please use the adhesive tape and maybe in combination with the bracket
(sold separately) to place the Busylight with good visibility for office
workers. Can be above or next to door/entrance
CONNECTING THE BUSYLIGHT
Please make sure the Flowscape Busylight are added as a class C device on the
LoRaWAN network (See user guide provided from your network provider)
Please make sure LoRaWAN Gateways are in reach of the device. Connect the USB
and power adaptor
Plug in adaptor to power socket to power-up the Flowscape Busylight The device will start up with a white blink, followed by week yellow color. In this mode it will search for LoRaWan network.
The light turns into a week green color when connected to the Lo-RaWan
network.
If no connection is made, the device starts to flash week red after
approximately 10 min.
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
PLEASE NOTE: The device can only be controlled over the LoRaWan network This product is not a USB device- USB cord for power purpose only
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>