Shantou Peirong Intelligent Technology 368 2.4GHz Assembled Battle Car Instruction Manual

Peirong Intelligent Technology 368 2.4GHz Assembled Battle-Car
Instruction Manual

Packing List

BATTERY INSTALLATION FOR REMOTE CONTROL CAR AND REMOTE Charging version
Assemble the battery into the battery slot corresponding to the correct electrode and close the battery cover.(Include)

The remote control uses 2 1.5V AA non-rechargeable batteries. (Not included)

CHARGE THE CAR BATTERY ****

Switch off the remote control car then disconnect the remote control car and batteries. Remove the rechargeable battery set. Then connect the battery charging head to the USB charging head correctly.
CAUTION
When the USB sign light turns to red, that means it is charging normally. The charging time is 180 minutes. It is fully charged when the red light is off.
NOTICE:
Assembled battle car movements are slow and the remote control is not sensitive. indicates insufficient electricity. and needs to be replaced.

HOW TO FILL IN WATER TO THE BATTLE CAR

Put the switch of the car to “OFF”, open the plug on the car, and use the water filter to add water to the car.
TIPS Remote control car is not waterproof. Be cautious when Ali is in water use the water, Pea. METHOD FOR ADDING A WATER BOMB
Push the water injection inlet opening, pour the water bomb, and cover the cover.

MAIN BODY INSTALLATION AND DISASSEMBLY MOUNTING OF BULLETS AND EMITTERS

MOUNTING FOR SOAKING WATER BOMBS

DISASSEMBLER EMITTER

START BATTLE CAR AND PAIR WITH THE CONTROLLER
Put the switch to “ON” to turn on the car. Note: After turning on the car, if the remote no has signaled for more than 5 minutes, the pairing is unsuccessful, and the car will enter sleep mode.

Turn the switch of the remote on to open the remote control. Note: When turning on the car,if not open the remote, the pairing is unsuccessful, the car will enter the sleep mode after 5 minutes.
The pairing the car and the remote Make sure the car and remote control have batteries installed and have already started. There are 2-3 seconds for pairing. The light on the remote keeps flashing and when the light is off,it means the pairing is successful.2.4G control, one remote matches one car and multiple cars operate without signal interference. Finish the pairing then you can join the battle.lf the car doesn’t respond to the remote, shut down both of them, and open and pair again(Same procedure as above).

FUNCTION DESCRIPTION

FUNCTION DESCRIPTION
WATERBOMB

The short press will fire continuously for 1.5 seconds,Long press will continue to fire.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

BATTLE CAR PLAY

FIGHTING MODE
Shooting techniques need to be improved by exercises. To hit the gunsight accurately, you can start exercising from the big gunsight. Change to shoot the small gunsight after you are skilled. Novice and expert fighters can compensate for the difference in attack power by installing different gunsights. BATTLE LIFE
Each time hit the gunsight, the car gives a “shudder”, and the light flash means that it is hit. If the gunsight is hit 4 times, the headlights and the blue light flash quickly, the game is over, quit the battle in defeat, and 2 minutes after will enter sleep mode. To re-join the battle,long-press the shooting button for about 3 seconds to restart wain.
Power-saving mode: If you don’t operate within 5 minutes, go to sleep mode, and you must shut down to restart.

FREQUENTLY ASKED QUESTIONS AND SOLUTION

on pages 2 and 3. Remove and then re-install the emitter in place again.
The battle car can’t match the remote control| The battery is low need to pair again| Replace the battery
Refer to page 2 for how to pair
No bullets fall after being hit| No correct installation| Refer to page 2 to learn how to properly install
---|---|---
The battle car does not work properly| No entering battle mode| Put the switch to “ON”
The LED of the battle car is alternately flashing| Battery is insufficient| Replace the battery

WARNING

The product includes smaller parts, not suitable for children under 3 years old.

• Suggested age: 14 years old or more
• This product uses a 2.4G digital transmission frequency.
• Do not shoot eye and face;
• Do not use it near the crowd;
• Do not shoot people and animals;
• Do not use it close to your ears;
• Use only product original ejects;
• Do not emit the face to the ejector the face at any time;
• Laser radiation, do not touch the light beam;
• Please retain this specification for future reference

Notice

• Make sure the battery lid is closed.
• Use the correct model and the type of battery.
• Install the battery in accordance with the positive and negative electrode identification.
• Change the battery to the battery when replacing the battery.
• Remove the battery exhausted battery from the device.
• Take the battery out for a long time.
• Keep the battery away from young children to prevent young children from swallowing.
• If you appear or speculate on the child’s swallowing battery, send a medical institution immediately.
• The battery should be installed in an adult.
• Do not close the battery near the fire source.

CAUTION

1. The remote control uses a 7.4V rechargeable lithium battery, the remote control uses 2 capsules of 1.5 “AA” non-rechargeable batteries.
2. Non-rechargeable batteries are not charged;
3. The charging battery can only be charged under adult monitoring;
4. The charging battery should be taken from the toy before charging;
5. How to remove and put the battery: release the screw with a screwdriver, unveil the battery cover, put it in and remove the battery according to the correct polarity;
6. Take out and put the battery shall be carried out in the logo on the toy battery chamber;
7. You can only use the same or the same battery as the recommended battery;
8. Do not mix new and different types of batteries;
9. The battery should be placed in the correct polarity;
10. Exhausted batteries should be removed from the toys;
11. The power terminal should not be shorted.
12. Cannot connect more than the recommended number of power supplies;
13. Toys cannot be used for children under 3 years old, toys can only use recommended USB charging lines, USB charging lines are not toys;
14. Toy cleaning should be disconnected from the USB charging line;
15. This product can only be charged using the USB charging line, and cannot use non-factory USB charging lines;
16. USB charging cable is completed by parents;
17. Regularly check the damaged wire, plug, housing, and other components. If the damage should be stopped, please contact the merchant to replace or purchase it immediately.

WARNING:
CHOKING HAZARD-Small parts. Not for children under 3 years.
WARNING
When the remote can not control the car, switch off the power of the remote first, then switch off the power of remote control car. Turn on the power again to have pair by pulling the controller on the remote.
CAUTION

1. Keep away all small OWLS safely, and avoid children swallowing.
2. When the electric wave disturbs playing, please find somewhere else.
3. Slop playing when the battery is low.
4. Dispose of all the package waste in the cared tin to avoid pollution,
5. Please keep the remote and the car in a cool and dry place
6. Do not storage dose to the fire. heat or wet place.
7. Wean the batteries soak with water, please dry it property. Do not use the battery anymore when the shape of the batteries has been changed.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>