USI MT7697HD Hardware Development Kit User Guide
- June 5, 2024
- USI
Table of Contents
USI MT7697HD Hardware Development Kit
Introduction
DESCRIPTION
This is a development kit for the MT7697HD Module (WM-BAN-MT-41). The
dimension of the board is 60mm x 80mm and the module is controlled via micro
USB. It provides multiple IO functions such as I2C, SPI, ADC and GPIO and rich
software libraries based on the MTK’s SDK for various IOT
applications.
FEATURES
- IEEE802.11a/b/g/n and 802.11n 1×1 Dual-Band 2.4G/5G with 20Mhz and 40Mhz bandwidth
- Integrated RF Power Amplifier
- Wi-Fi Security Support (Including WAPI)
- Bluetooth 4.2 Low Energy(LE)
- Support SCO and eSCO link with re-transmission
– MCU
- ARM Cortex-M4 CPU with FPU with up to 192Mhz clock speed
- Embedded 352KB SRAM and 64KB boot ROM
- 4MB Quad Peripheral Interface(QPI) mode SIP serial flash
- Support external serial flash up to 16MB
- 28 GPIOs multiplexed with other interfaces
Hardware Description
The following shows the USI MT7697HD development kit
Block Diagram and Features
Features on the EVK
- USI MT7697HD module with on-board printed antenna , support 802.11a/b/g/n and BLE 4.2
- Arduino Uno V3 expansion connector
- On-board IPEX-SW23 connector for RF performance evaluation
- Pre-programmed NXP-MK20 for RF testing and SW development/debugging
- buttons (S1->Reset/S2->Programming mode/S4,S5->Interrupt)
- LEDs for indicating the 3V3 power supply
- Standardized connector (J7) for I2C
- Pin header (JP30) for current measurements (Remove jumper, 3V3 is going through a 1ohm resistor)
- Reserved UART headers (JP33 and JP34) for external host control.
(Jumpers on JP33 and JP34 should be removed for external host control) - Reserved JTAG headers for MK20’s re-programming
USI reserves the right to make changes, without further notice, to any products or data to improve reliability, function, marking, and/or design. Any products, data or information furnished by USI is that USI believed to be accurate and reliable. However, USI shall not assume any liability arising from the application or use of such products, data and/or information. For Additional information, please contact the following: Universal Global Scientific Industrial Co., Ltd. Headquarters
- 141, Lane 351, Taiping Road, Sec. 1, Tsao-Tuen, Taiwan, Http://www.usiglobal.com/
- Tel: + 886-49-2350876, 2325876
- Fax: +886-49-3439561, 2337360,2351093
- E-mail: tw.gp.wpeastsale@usiglobal,com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>