Skylead Industry APD-10 Remote Control For Drone/Helicopter Instruction Manual

Sky lead Industry APD-10 Remote Control For Drone/Helicopter

AIRCRAFT BATTERY CHARGING AND CAMERA INSTALLATION INSTRUCTIONS

CHARGING HELICOPTER

1. Charging helicopter battery PC using USB cable: when charging is completed, lights off.
2. Installing battery into helicopter Install fully-charged battery into to a USB port for charging the power supply for charging battery socket of a helicopter, connect the battery with helcipter power-input

INSTALLATION DIAGRAM

Two interfaces of aircraft are described· The external interface is the camera connection interface. (Additional cameras are available) The inner interface of the battery bin is the battery interface

REMOTE CONTROL WIFI FIXED HIGH VERSION

CONFIGURATION DIAGRAM

Note:
the video and photo key is installed cameras can be used Read the instructions before use, please complete part (attention and warning please read) keep this manual for later use

Note:
Please check the number of accessories carefully(as shown above). Please provide proof of purchase and contact the store for replacement if any missing parts.

INSTALLATION DRAWING OF REMOTE CONTROL MOBILE PHONE CLIP AND

BATTERY

1.  take out the small cover
2.  install the mobile phone clip (as shown in Figure 1) (as shown in Figure 2)
3.  Installation is completed (as shown in Figure 3)

Open the battery cover, in accordance with the instructions right into the electrode 3 “AAA” 7 alkaline batteries. (batteries are subject to buy)

PLACEBATTERIESACCORDINGLY (+/-)

Charging helicopter battery

1. Connect helicopter battery with PC using USB cable: when charging, lights on; when charging completed, lights off
2. Install fully-charged battery into the battery socket of the helicopter. connect the battery with helicopter power-input

PRE-TAKEOFF INSTRUCTIONS
After power the switch charging to the “ON” completes, the position put the When drone the on level helicopter’s surface LED and light turn flashes, the LED power light on the turns remote from flashing control to to solid proceeds indicates pairing the That process the of remote pairing control’s has (The been process successful of and pairing the takes helicopter about 3 iS ready seconds.) for other operations.

1. Takeoff in altitude hold and landing Instructions
2. Turn on for 3 seconds, then about 2 seconds to rise of 1 meter after enter in idle state. Press a second time to land, and the blades rotate slowly, the aircraft lands slowly. Pressing the button for long time lo stop landing

Before take-off, calibrated the aircraft position, ensure it is in the best condition. ( See pie.)The hovering aricraft is able to be gaining height after pushing up the left joystick, or pull down to resuce height, and to adjust to be a right height
ATTENTION: Make sure batteries and charger are connected correctly

WARNING

•  This product is not a toy, it is a high-tech device that required accurate assembly, adjustment and proper operation in order to prevent accidents. The user of this device should use it properly and it is the user’s responsibility to make s.ure it does not bring harm to others or other’s property
• this product is not suitable for children under 14 Choose a location where playing this device is legally allowed.
•  Our company and sales agents are not responsible for any damage caused by improper use.
•  For further technical support and customer service, please contact your local sales representatives.

SAFETY PRECAUTIONS
Quadrotor helicopters could cause severe damage, therefore, make sure to avoid crowd while playing. Accident might be caused by improper assembly and control, as well as by operating an damaged helicopter or damaged remote control. Users of this product should be”aware of any potential damages and use this product cautiously.

1.  Avoid obstacles and crowd : As the quadrotor helicopter might sometimes have unstable flying speed and status,il should be played in a place away from crowd, high building, high•votage line, and avoid bad weather(rain,willd, stolTT’l,etc),so as to prevent harm to the user and other individuals.
2.  Keep it and play it away from humid place: This product contains precise technical elements which might get disfunctional due to humidity
3. Safety control: Do not play when you are tired as the control required full concentration. Play more considerately if you think your control technique is not mature enough
4. Keep away from running rotors: Users and another person should always keep away from running rotors.
5. Keep away from heat: This product is composed of metal.fibre.plastic, electric parts, therefore it should be kept away from heat, or else it might get damaged.

Additional Accessories Installation

Flying control

1. Accelerator(left stick)
2. Forward/backward(right stick)
3. EDWARD FLY
4. LEFT/RIGHT TURN

MICRO-ADJUSTMENT

FORWARD/BACKWARD MICRO-ADJUST

SIDEWARD MICRO-ADJUST

HLCH/LOW SPEED

Deploy the aircraft according to steps

Helicopter affect weight flying will hour and increase life with length of additional engine. accessories.

EXAMINE AND REPAIR

FCC STATEMENT

NOTE:
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMJTS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:

•  REORIENT OR RELOCATE THE RECEIVING ANTENNA.
•  INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
•  CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
•  CONSULT THE DEALER OR AN EXPERIENCED RADIO.

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.THIS DEVICE COMPLIES WlTH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED. INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>