Guangzhou Chiming Electronic Technology CM-3003C Device Instruction Manual
- June 5, 2024
- Guangzhou Chiming Electronic Technology
Table of Contents
Guangzhou Chiming Electronic Technology CM-3003C Device
WHAT IN THE BOX
TWO KINDS OF FIXED FRAME
**INSTALL STEP
**
THE LAST
THE STEP OF SINGLE CONTROL
THE STEP OF MULTIPLE GROUP CONTROL
Technology parameter
- Input Voltage: DC12-24V
- Output power:2A 3, common Anode
- Control mode:mobile phone+infrared direct control
- Gray scale:256 256″256
- Total brightness level:8 grade
- operating temperature:-20C-50C
- IP Grade: LP 67
- Size: 79 47*21 mm
Open the APP show the ” Wireless connection fails”
please check whether your Wireless device in a state of electricity please
check whether your Wireless device is within range of a mobile phone Wireless
usually mobile phone Wireless is within 10 meters,different mobile have
different distances. please refer to the previous “Wireless device connection”
to reconnect the device.
The color of the Light can not match the setup color
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: This device may not cause harmful interference,
and this device must accept any interference received, including interference
that may cause undesired operation. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>