CMI HEALTH PC-66H Handheld Pulse Oximeter User Guide
- June 5, 2024
- CMI HEALTH
Table of Contents
PC-66H Quick Guide
Product Overview
Screen Display
Changing Batteries
-
Open the battery compartment with a coin. Turn the screw counter-clockwise to open.
-
Replace all three old batteries with three new batteries.
*Please DO NOT mix new and used batteries or use rechargeable AA batteries.
How to Use and Take a Measurement
Line up arrow signs, then insert the cord.| Open the cap and connect the
converter cable with the other end of the SpO2 sensor.| Insert one finger into
the sensor and start your measurements.
---|---|---
| |
Alarm Set-up
| 1. Press and hold ”Mode/OK” for 2 seconds to go to the menu.
---|---
| 2. On the menu screen, select “Setting” and then press “Mode/OK.”
| 3. Use to move the cursor and select the type of threshold for alarm.
Example shows SpO2 Lo-limit.
| 4. Press ‘Mode/OK” to change the default value. A highlight will show on
the screen, and be used adjusted to the desired threshold value. (see pg.13 in
the user manual for more details).
| 5. Once confirmed, press “Mode/OK” to save the change and (power/back) to
exit from the alarm setting.
Mute Beeping Sound
- Short press the mute button to mute the beeping sound.
- The alarm sound will go off if the measurement is out of the limit or the sensor fell off. You can adjust the alarm thresholds based on your need.
*Please be aware that the mute function would be overwritten by alarm onset or power off. Short press the mute button again if either situation occurs.