treed VD57 Smartwatch Instruction Manual

Table of Contents

DISPLAY AND CROWN/BUTTON OPERATION

the measurement time indicated by the stopwatch hands that move independently of center hands. “Stopwatch 1/10 second hand moves for a first minute.
After one minute, it indicates the measurement time when it is stopped.

ADJUSTING THE STOPWATCH HAND POSITION

Before setting the time, check if the stopwatch 1/10 second, second and minute hands are in the “0” (12 o’clock) position.

If the stopwatch is in use, press the button in the following order to reset it, and then, check if the han return to “O” position. (For details, see “HOW TO USE THE STOPWATCH”)
If the stopwatch is counting: A B
If the stopwatch is stopped B
If the split time is displayed B A>B

If either of the stopwatch hands are not in the “0” position. reset them following the procedure below.

Pull the crown out to the second click.
Press button A or B to reset the stopwatch 1/10 second, second and minute hands to “0” position.
- By pressing button A set the stopwatch 1/10 second hand.
- By pressing button B set the
Push the crown back to the normal position. stopwatch second and minute hands.
- The stopwatch minute hand moves correspondingly with the stopwatch second hand.
- The hands move quickly if the respective buttons are kept pressed.

TIME SETTING

Pull out the crown to
Turn the crown clockwise
Pull out the crown to the
Push the crown back in the first click. until the previous day’s date appears.second click when the to the normal position in second hand is at the accordance with a time 12 o’clock position. It will stop on the spot signal. and advance the hour and minute hands by turning the crown. (Check that AM/PM is set correctly.)
- When the crown is at the second click position. Do not press any button. Otherwise, the chronograph hands will move.
- Do not set the date between 9:00 P.M. and 1:00 A.M. Otherwise, the day may not change properly. If it is necessary to set the date during that time period, First change the time to any time outside it, set the date and then reset the correct time.

HOW TO USE THE STOPWATCH

The measurement time is indicated by the stopwatch hands that move independently of the center hands.
The stopwatch can measure up to 60 minutes in 1/10 second. (The watch indicates the measurement time in second increments by ignoring off the 1/10 seconds obtained.)
- Restart and stop of the stopwatch can be repeated as many times as necessary by pressing button A.
- Measurement and release of the split time can be repeated as many times as necessary by pressing button B.