tamforce Industrial Vacuum Cleaner 3000W Instruction Manual

Instruction Manual
ID 1009 3347
Dry-/wet Vacuum Cleaner

Characteristics

1. Vacuum cleaner for wet and dry
2. With double wheels motor, motors work at the same time with stronger suction
3. Jacks on the base, easy for depositing accessories
4. With special and good-looking design, Suitable for hotel, office, factory etc.
5. Stainless steel barrel for permanent use

Choose suitable accessories for different occasions.

*Wet floor nozzle for floor carpet etc.

*Crevice nozzle for crevice, corner, etc.

*Bristle for window, table etc.

Safety Instruction

1. Check before operation that the power voltage is the same as the specification on the rating label;

2. Do not use the machine in a combustible and explosive place in case the motor spark causes a fire.

3. Do not jam the air inlet mouth, in the case causing the high-temperature rise and damage the motor.
   Do not pick up sharp objects.

4. Do not pick up combustible and explosive objects such as glowing cigarettes, gasoline, etc. Do not pick up sharp objects.
   Do not pick up objects which easily attach to the filter such as calcareousness powder, gesso, and graphite powder that will block the ventilation and damage motor.

5. Warning:
   If water out from the air outlet mouth, do not overturn the machine when repairing in case the water goes into the motor and causes damage Do not use this machine as a pump in case damaging the motor.

6. Turn off the machine and remove the plug each time after using or when repairing.

7. Keep the machine away from strong sunlight and high-temperature place in case the plastic distorts.

8. Do not wrest, tramp, or haul hose in case make it damaged.

9. Do not immerse water into the barrel cap or wash the barrel cap with water in case water goes into the lactiferous parts and causes a person injury. The correct way should be: Immerses the dishcloth then tweak it to be dry. Wipe the dirty part gently.

10. Do not use children or not mature people.

11. When clearing the stair, do use extra protection in case the machine falls off when moving the hose.

Use Instruction

1. Connection
   Insert the hose connector into the air inlet mouth as picture shows, and make sure the connector is tightly fastened.
   Connect all the accessories as the picture shows.

2. Check whether the dust filter is put in before the operation.

3. Take away all the things in the barrel including the dust filter before the wet use.

4. Put the power cordless at the right back of the Connector terminal when using the machine.

5. Insert the plug into the supply socket.

6. Press the switch button, and the machine begin to work.

Protection Device

Special instruction concerning protective device

1. When the water in the barrel is full, the device begins to work. The suction power with vanish at this moment. The machine will make a noise which indicates the motor is running at a high speed. Under this circumstance, you should cut off the electricity, and clean out the water. Then equip the machine and turn it on, and it will begin to work normally.

2. Only connect to a proper 220-240 volt.50 Hz socket

3. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent by a similarly qualified person in order to avoid a hazard.

4. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless
   they have been given supervision or instruction or instruction concerning the use of the appliance by a person responsible for their safety.

5. Children should be supervised to ensure that they do not play with the appliance.

Correct Disposal of this product

This marking indicates that this product should not be disposed of with other house­ hold wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was pur­ chased. They can take this product for environmentally safe recycling.

Warranty Information

The manufacturer provides a warranty in accordance with the legislation of the customer’ sown country of residence, with a minimum of 1 year (Germany 2 years), starting from the date on which the appliance is sold to the end user.
The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service center. When making a claim under the warranty, the original bill of purchase (with purchase date) must be submitted.
The warranty will not apply in cases of:

• Normal wear and tear
• Incorrect use, e.g. overloading of the appliance, use of non-approved accessories
• Use of force, damage caused by external influences
• Damage caused by non-observance of the user manual, e.g. connection to an unsuitable mains supply or non-compliance with the installation instructions
• Partially or completely dismantled appliances

Maintenance

1. Barrel Cleaning
   After working or when the barrel is full of dust which causes suction decreases considerably, you should cut off the electricity and clean the dust away from the barrel.

1. Unfasten the locking knob. lift up the top cover.
2. Take off the filter bag, and clean the dust away in the dust barrel.
3. Install the filter bag back and place the top cover.
   (The position of the power switch and air inlet mouth should be in the same direction.)

2. Filter bag cleaning
   The filter bag should be washed with clean and warm water when it was covered with dust. If necessary, you can use limitless scour to wash.

1. Take off the filter
2. Wash
3. Dry

WET/DRY VACUUM CLEANER

Technique Parameter

Accessories

1. Handle
2. Coating
3. Power cable
4. Top Cover
5. Switch
6. Middle cover
7. Pad
8. Spong
9. Capacitor
1 0. Middle cover gasket
11. Air outlet sponge
12. Upper gasket| 13. Motor
14. Lower gasket
15. Air inlet blocking board
16. Motor pedestal
1 7. Barrel cover
18. windtight ring
1 9. Protective valve
20. Pedestal basket
21. Support basket
22. Filter
23. Barrel
24. Barrel lock| 25. Locking block
26. Turnover part
27. Turnover shelf
28. Turnover support shelf
29. Base big handrail
30. Axle press-cover
31. Axle
32. Axle press-bottom
33. Cork
34. Rubber wheel
35. Wheel
36. Pedestal| 37. Tight gasket
38. Water outlet
39. Rubber gasket
40. Water outlet screw
41. Water outlet hose
42. Connetor ring
43. Water outlet coating
44. Handle pedestal
45. Stainless steel tube
46. Sucktion pedestal
47. Ring
48. Sucker mouth
---|---|---|---
EU DECLARATION OF CONFORMITY

1. Product identification number
Model/type/batch/serial number WL70-8013BNAC0UM CLEANER
2. Name and address of the manufacturer of the manufacturer’s authorised representative
Company name
ZkIERANG ROLY TECHNOLOGY CO,LTD| telephone number
0579-87208797
Postal address
366 HUAXIA ROAD ECONOMIC DEVELOPMENT ZONE YONGKANG ZHERAN6 CHINA
Postal code and city
321300 YONGKANG CITY|  E-mail address
sales9Mrolycn.com
3. Authorized to compile the Technical File
Company name| Address
Virkatie 7, 01510, Vantaa, Finland
4. This declaration of conformity was issued at the sole responsibility of the manufactures
5. Insured item
 Product Product name/ description
Tuotteen nimirkuvaus/3000W SOL wet and dry vacuum cleaner| Brand
Twaternerkki TAMFORCE
 Model/type
WL70-130L38/VACUUM CLEANER| Other details of the description, e.g image
Muut kuvaustiedot, esim. kuva
6. The insured item described above is compliant with the requirement of the EU legislation on harmonization
Please list here all directives and decrees regarding the device
20M/30/EU
2014/35/EU
2011/65/W
7.  Reference to the appropriate harmonized standards used, or reference to other technical specifications based on which the declaration of conformity was issued
 EN550141:2017 EN62233:2008
EN550142:2015 ASPS GS 2014:01 PAK
04610004-2:2014 EN610003-3:2013 EN60335-2-2:2010.A11:2012.A1:2013
EN60335-1:2012.A11:2014.A13:2917
8.  Notified body (identification] carried out [description of the procedure] and issued the filming certificate
Name and ID number of the notified body
UROFINES PRODUCT SERVICE GMBH| Procedure, module| Reference information of the certificate or decision issued by the notified body
CB EMC GS CE
9.  Addition I Information
No Addition information
Place and date
2021-01-15 YONGKANG CHINA| authorized representative
ZHEJIANG ROLY TECHNOLOGY CO., LTD
---|---
Signature
GUANGXIONG YANG
MANAGER

ID 1009 3347
Dry-/wet vacuum cleaner

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>