JBT CBU12-24VDD-YJ Control Box Instruction Manual
- June 5, 2024
- JBT
Table of Contents
JBT CBU12-24VDD-YJ Control Box
Product Name: Control Box
Product parameters: Input: 12-24VDC
Frequency Range: 2404MHz~2480MHz
Model: CBU12-24VDD,CBU12-24VDD-YJ
Product Features
NO.|
type
| Features
---|---|---
1
|
button
| Press and hold for 3 seconds to quickly enter the network configuration mode.
2
| After the network is configured, the light can be turnedon and the scene mode can be freely switched.
3
| Double-tap to turn off the lights.
This control box is a control box used with LED light strips. It is mainly used to control the network configuration switch and dimming of the lamps.
Steps
Distribution network operation
- Turn on the phone’s Bluetooth and connect the phone to a 2.4GHz Wi-Fi network.
- Press and hold the switch button on the controller for 3 seconds or switch it 3 times (on-0.5S off-0.5S on-0.5S off-on), then the flood light flashes quickly (2 times/second).
- Open and log in the Smart Life APP, click the add icon in the upper right corner.
- Click [Auto Discovery], the phone will automatically search for devices.
- After the addition is successful, click Finish to jump to the control page.
The other four distribution network modes of the product
-
APP pop-up window distribution network:
After the device is powered on and flashes to open the APP interface, it is found that the device pushes a pop-up window to remind you to add the device network connection -
Bluetooth manual add:
Power on the device and quickly open the APP to add a device interface Manually add a Bluetooth device Click to search to find the device network connection -
EZ distribution network:
The device is powered on and flashes quickly to open the APP add device interface to manually add a WIFI device, EZ mode distribution network connection -
AP distribution network:
Power on the device. Press and hold the power button for 5 seconds, and the indicator light will flash slowly. Open the APP add device interface to manually add a WIFI device, EZ mode, click slow flash (once every 2 seconds) to connect to the network.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receivingantenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.