Shenzhen Ximalong Hi Tech E1 Intelligent Visual Ear Pick Instruction Manual
- June 5, 2024
- Shenzhen Ximalong Hi Tech
Table of Contents
Shenzhen Ximalong Hi Tech E1 Intelligent Visual Ear Pick
PRODUCT OVERVIEW
Product parameters
- Product name:Intelligent visual ear pick
- Network Standard: IEEE 802.11b/g
- Product Model: E1
- Operating Frequency: 2.4GHz
- Ambient Temperature: -10’c-+50’c
- Image Sensor: CMOS
- Battery Capacity: 130mA
- Lens Diameter: 3.5mm
- Charging Time: 45 minutes
- Image Transmission Pixel: 500W
- Use Time: 65 minutes
- Image Transmission Rate: 30FPS
- Working Voltage: 3.7V-4.2V
- Gravity Sensor: 3-axis smart gyroscope
- Input Voltage: 5V-1A
- Product Size: 614mm * H145mm
- Output Power: 0.5W
- Product Weight: 14.2g
- Charging interface: Type-C
Product accessories
- Main unit x1
- Type-C charging cable X1
- Instructions 1
- Accessories Bucket 1
- Silicone Earpick Sleeve x6
Cautions
- It is recommended to carefully clean the lens with cotton swab.
- Please observe the surroundings before use, do not use it in an environment where it may come into contact with moving people or animals, do not use it in a moving vehicle, or in other unstable environments. Please keep your body stable when using it
- This product is not suitable for children under 3
- To avoid accidental injury, children are prohibited from using this product alone.
- Do not place the machine in a humid environment for a long time, or immerse the whole machine in liquid.
- The product has built-in polymer battery, which must be charged once a month if not used frequently.
- Please charge the device with 5V charger. It is forbidden to use this device when it is under charging state.
- Avoid exposing the product to direct sunlight.
- Do not place heavy objects on top of the machine.
- During use, the temperature of the product will rise slightly (up to about 35°), which is normal
TROUBLE SHOOTING
If the above operation still fails to solve the problem, please contact our
customer service staff, we will further provide you with practical solutions
.
WARRANTY
FCC STSTEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>