House Of Haos 2AXGP DIACOM FREQUENCY GENERATORS UP TO 1MHZ User Manual
- June 5, 2024
- House Of Haos
Table of Contents
“Diacom Technology”
INFORMATION-MEASURING DEVICES OF THE «DIACOM» TYPE
WITH A LOW FREQUENCY GENERATOR MODULE UP TO 1 MHZ AND FREQUENCY
GENERATORS UP TO 1 MHZ
«Diacom-Lite-FREQ», «Diacom-Lite-FREQ-Euro»
«Diacom-Lite-FREQ-Utium», «Diacom-SOLO-NLS», «Diacom-NLS-minica»,
«Diacom-SOLO-FREQ-Personal-Medio», «Diacom-SOLO-FREQ-Home», «Diacom-SOLO-FREQ-
PC»
User manual
Guarantee manual
Warranty certificates
Introduction.
The present devices have been developed on the basis of own researches as a result of which the invention which has become a basis of manufacture of the above-stated devices has been carried out. Subsequently, a patent for the invention was obtained, confirming the originality of the technology used in the devices, under the number – RU0002721874.
https://patentscope.wipo.int/search/en/detail.jsf?docid=ru238125876&_cid=p22-kbphxg-106662
The invention belongs to the methods of diagnostics by physical parameters, in particular, diagnostics of electromagnetic fluctuations of biologically active zones and their influence on the human body, as well as diagnostics of the human body in case of violations at the cellular level. A method of detecting oscillations of low-current electromagnetic fields, wherein near an object of investigation, weak electromagnetic radiation is successively generated with frequencies from a set of desired frequencies; then parameters of frequency attenuation amplitude in the inductance coil circuit are recorded and the obtained data are compared with measurement data of similar parameters in the absence of the object of investigation; if discrepancies are detected, the given frequency is identified as searched, data on it is entered into a database for subsequent comparative analysis.
The publication was also carried out in the international scientific research journal “Science and World”, number # 9 part # 2 of 2017.
RELEVANCE OF REGISTRATION OF ELECTROMAGNETIC FIELD FLUCTUATIONS OF
HUMAN ORGANISM CELLS’ AS A METHOD OF EARLY DISEASE DETECTION AND ITS PRACTICAL APPLICATION IN MEDICINE
Kh.D. Mkrtchyan, PhD in Biomagnetic Resonance and Natural Medicine
Recognized as the Open University of Modern Sciences,
Branch in Barcelona, Spain (OUAS)
Abstract. In the present article, the registration methods offiuctuations of the cells’ electromagnetic field or “biomagnetism” as a basic information source of the cell’s state and its forthcoming changes are considered. The understanding of the phenomenon’s nature will help to perform inexpensive, early diagnosis of various pathologies of tlw human and also to prevent not only its consequences, but also to completely exclude diseases, which can be caused by frictional violations in cells’ work of an organism. This article is caused by the need of clearing of that chaos, which has arisen in the field of the newest methods of diagnostics based on developments and achievements of the last years, which have allowed to make considerable breakthrough in understanding of cells’ structure and information metabolism between them.
Keywords: bioresonance therapy, biomagnetism,.fluctuations,.field, diagnostics, physics, medicine.
http://scienceph.ru/f/science_and_world_no_9_49_september_vol_ii_0.pdf
The article is on page 26.
This article discusses methods for registering oscillations of the
electromagnetic field of cells or “Biomagnetism”, as a basic source of
information about the state of the cell and its upcoming changes.
Understanding the nature of the phenomenon will help to carry out inexpensive,
early diagnosis of various human pathologies, as well as prevent not only its
consequences, but also completely eliminate diseases that can be caused by
functional disorders in the body cells. This publication is caused by the need
to clarify the chaos that has arisen in the field of the latest diagnostic
methods based on the developments and achievements of recent years, which have
allowed making a significant breakthrough in understanding the structure of
cells and information metabolism between them.
The full text of the article can be read at:
http://scienceph.ru/f/science_and_world_no_9_49_september_vol_ii_0.pdf
Certification plays a very important role in product manufacturing.
All products have passed the necessary certification in the Czech Republic and in several other countries. Can be marked with a sign .
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 18 of the FCC Rules. This equipment
generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the users authority to operate this equipment.
About the devices.
Devices are designed for generation and measurement of electromagnetic
oscillations by method of comparison of natural frequency of internal
generator and frequency of measured object. Data can be displayed on a
computer monitor and presented in graphic form and in the form of digital
arrays, for subsequent analysis. To operate devices, Diacom Technology has
developed a number of programs that can be downloaded on the company’s website
at www.diacom.technology in the “Programs”
section.
A conventional unit is used to measure data. A signal span ranges from 0 to
100 conventional units. The device can also generate frequencies up to 1 MHz.
The software also uses various graphical indicators when working. The software
is designed for detection of biologically active zones, analysis of their
changes, as well as for detection of pathogenic microflora, which can affect
the normal vital activity of humans and animals. Studying and analyzing the
general mutual influence of pathogenic microflora and changes in
electromagnetic fluctuation in these processes.
In order to obtain the skills of correct work with the software developed by
Diacom, it is necessary to undergo training.
Minimum system requirements for “Diacom” devices.
Intel-Core i5 or higher processor at least 2.0 GHz,
RAM is not less than RAM OF 6 GB,
SSD Disk Space 10 GB
Screen permission is minimum: 1360768 High Color 16 bit
Monitor 17´ and more
OS isn’t lower Windows 10 and above
One free USB port.
How to connect the “Diacom” device to the computer.
Before connecting the device to your computer, you should download the necessary software from the company’s website, to the web addresses indicated on the packing list or from the web address: www.diacom.technology. Install the driver of your device, according to its name, the standard method for installing drivers for Windows OS, “Warning” when connecting the device to your computer, you may need to confirm that the device driver is up-to-date, which is not its reinstallation. Next, we install software to operate the device. Run the Software Installation Wizard and, by clicking the active buttons of the Installation Wizard sequentially, carefully reading its messages until a button appears indicating that the installation has finished, install the device software on your computer. Each device type has its own software package.
How to operate the devices «Diacom-Lite-FREQ», «Diacom-Lite-FREQ-Euro», «DiacomLite-FREQ-Utium», «Diacom-SOLO-NLS», «Diacom-NLS-minica», «Diacom- SOLOFREQ-Personal-Medio», «Diacom-SOLO-FREQ-Home», «Diacom-SOLO-FREQ-PC».
- Connect the “Diacom” device to a computer with software and drivers installed.
- Turn on the device with the toggle switch located at the back panel. (“Diacom-SOLO-FREQ-PC” turns on immediately when connected to a computer and is not equipped with a toggle switch).
- Run the required program.
Disconnect in reverse order!
Attention!
Supplying more than 3 V. electrical voltage to the inputs of the “Diacom”
device can lead to a failure of the input and output circuits of the device
and make it unsuitable for further operation, while the warranty obligations
will lose force.
Any attempt to open the device or remove the protective sticker deprives the
owner of the device of the warranty, and the manufacturer is not responsible
for the consequences of these actions!
Design and technical features and differences of devices, a brief description.
«Diacom-Lite-FREQ» – the device is equipped with a measuring module, intra- circuit heterodyne and a module for additional generation of low frequency. Designed to work with programs measuring the frequency of low-precision oscillations and low frequency modulation programs.
«Diacom-Lite-FREQ-EURO» – the device is equipped with a measuring module, intracircuit heterodyne and a module for additional generation of low frequency. It is designed to work with programs for measuring the frequency of low-current oscillations and programs for modulation of low frequency.
«Diacom-Lite-FREQ-Utium» – the device is equipped with a measuring module, an incircuit heterodyne and a module for additional low-frequency generation. It is designed to work with programs for measuring the frequency of low-current oscillations and programs for modulation of low frequency.
«Diacom-SOLO-NLS» – device is equipped with measuring module, internal circuit local oscillator. Designed to work with programs for measuring the frequency of low-current oscillations.
«Diacom-NLS-minica» – The device is equipped with a measuring module, internal circuit heterodyne. Designed to work with programs for measuring the frequency of low-current oscillations.
«Diacom-SOLO-FREQ-PC» – the device is equipped with an internal circuit module of a low-power digital generator of low frequency. Designed to work with low- frequency modulation programs using a low-power digital generator.
«Diacom-SOLO-FREQ-Personal-Medio» – the device is equipped with an internal circuit module of a low-power digital generator of low frequency. It is designed to work independently with its own low frequency modulation program using a digital low power generator. Equipped with a graphic display.
«Diacom-SOLO-FREQ-Home» – the device is equipped with an internal circuit module of a low-power digital generator of low frequency. It is designed to work independently with its own low frequency modulation program using a digital low power generator. Equipped with LED indication. It differs from “Diacom-SOLO-FREQ-Personal-Medio” by a simplified proprietary program with predefined lists of specialized frequencies for the destruction of pathogenic microflora.
Block diagram of the “Diacom” device.
Limited warranty conditions.
The devices are manufactured in the Czech Republic. This warranty applies to all Diacom information and measurement devices, except for components and accessories that are not part of the main unit and are subject to mechanical impact during operation. These components and accessories, as defined by the manufacturer, are consumables. Such components are – cables, wires and accessories that do not contain active radio components (bio-inductors). On such components and accessories, the manufacturer does not install a sealing mark (security sticker, sealing). The start of the warranty period is considered the date of sale of the device and its commissioning and continues for the next two years. Delivery and receipt of the device for repair is the responsibility of the user and is paid by him independently. The manufacturer, at its sole discretion, can accept payment of transportation costs associated with warranty repairs and maintenance of the device.
The warranty obligation is renewable when a product is replaced with a more advanced one before the warranty period expires within the framework of companies and shares held by the manufacturer.
A defective device may be repaired or replaced with a similar device, at the manufacturer’s discretion, provided that this action is not detrimental to the consumer. Consumables can be purchased by the user additionally or under other conditions, by agreement with the manufacturer of the devices.
The warranty can be suspended if in the course of operation, the device was subject to mechanical impact, moisture, which led to its physical breakdown, failure, or if there were violations of the rules of operation of the device in terms of exposure to electrical voltage, as well as unauthorized attempts to open the device and damage the protective stickers.
Device that has passed the activation is not refundable!
- The terms of warranty service of the “Diacom” device are familiarized. I have no claims.
_____ / ____/
Release data.
Type (marking) of the device:
*Diacom- __
- Serial number of the device: __
From vendor ____
Official seal affixed by vendor
Dealer (vendor): ____
Device sale date: ___20____r.
from dealer __
Official seal affixed by dealer
(!) the warranty is invalid without filled-in fields indicated by an asterisk and seals.
Device acceptance and sourcing information.
Date of issue __ 20_____.
Complete set:
Main device
Bio-inductors
Reprinter
FREQ cables
USB cable
Manual
Cardboard packaging
Case
The device is packed ___
Date __ ____ 20_____.
- I have read the terms of sale and warranty obligations (see above) :
__ ( _____ )
«» __20____ .
Information on repair works performed.
1. Date of acceptance for repair
2. Comissioning date
3. Cause of malfunction __
4. Signatire (name of the receiver)
Official seal affixed by Vendor Official seal affixed by receiver
signature __ signature __
—————————————————————————————————-
5. Date of acceptance for repair
6. Comissioning date
7. Cause of malfunction __
8. Signature (name of the receiver)
Official seal affixed by Vendor Official seal affixed by receiver
signature __ signature ____
—————————————————————————————————-
9. Date of acceptance for repair ____
10. Comissioning date
11. Cause of malfunction
12. Signature (name of the receiver) ___
Official seal affixed by Vendor Official seal affixed by receiver
signature __ signature ____
- Without filling in the fields marked with an asterisk, the warranty is invalid.
Diacom Technology
Mkrtchyan Khachatur
Jedova 189, Neratovice 277 11
Czech Republic.
Produced in EU
Czech Republic
Prague 2020
Documents / Resources
|
House Of Haos 2AXGP DIACOM FREQUENCY GENERATORS UP TO
1MHZ
[pdf] User Manual
2AXGP DIACOM FREQUENCY GENERATORS UP TO 1MHZ, DIACOM FREQUENCY GENERATORS UP
TO 1MHZ, GENERATORS UP TO 1MHZ, UP TO 1MHZ
---|---
References
- DIACOM TECHNOLOGY - Diacom technology
- RU0002721874 METHOD OF DETECTING OSCILLATIONS OF LOW-CURRENT ELECTROMAGNETIC FIELDS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>