LINPA WORLD ARBT106 Wireless Bluetooth Speaker User Guide
- June 5, 2024
- LINPA WORLD
Table of Contents
LINPA WORLD ARBT106 Wireless Bluetooth Speaker
Keys and Functions
Bluetooth mode
- Step 1: Switch On and the prompt tone is: the Bluetooth device is ready to pair.
- Step 2: find ARBT106, and click Pair
- Step 3:After the pairing is successful, the sound prompt is: the Bluetooth device is connected successfully.
- Step 4: Disconnect Bluetooth, the sound prompt is: the Bluetooth device is ready to pair. Step 5: Switch Off, power off, Lights went out
Tips
- If you cannot find the paring name, other mobile phones may be connected. Please turn off Bluetooth on other devices, or walk away, or go 100 meters further and search again
- Delete the Bluetooth device name in the phone and search for ARBT106 again
Charge
- Please ensure that the charging equipment for the speaker is 5V (please do not use 6V, 9V or 12V voltage to charge the speaker, as there will be a risk of burning the chip)
- The speaker is charged once a month, electronic products do not charge for a long time will lead to battery self-protection can not start
Indicating light status
attention please
- Do not remove or modify the speaker to avoid damage or danger
- Do not clean the speaker with strong chemicals or cleaners, and keep the speaker dry
- Do not store the speaker in extreme temperatures (below 0 ° C, above 45 ° C)
- Do not use loudspeakers in heavy rain or lightning. Otherwise, the loudspeakers may become disordered and increase the risk of electric shock.
FCC STATEMENT CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>