Blendfflount J28 Innovative Mounting Solutions Aluminum Radar Detector Owner’s Manual
- June 5, 2024
- Blendfflount
Table of Contents
J28 Innovative Mounting Solutions Aluminum Radar Detector
Owner’s Manual
Your rear view mirror has a minimum clearance between the back aide of the
mirror and the mirror stem.
It la very Important that this mount la Installed correctly to ensure mirror
adjustability Is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror showed In
these Instructions may look slightly different than YOUR mount and rear view
mirror.
Before Installing this mount on your mirror observe how the spring clip functions. When used properly, the spring clip avoids putting excessive pressure on the mirror when Installing and removing the radar detector (RD). To release tension from the spring clip, simply squeeze the tab and the back side of the mount together. This will lower the bottom portion of the spring clip allowing you to slide the RD on and off the mount. Push the RD Release button and slide the RD onto the Spring Clip until you hear it lock into position, then release both the Tab and Release Button. Install and remove the RD a few times before installing the mount on your mirror. Once the Installation Is complete, the spring clip allows you to access the buttons on top of the RD while still having the RD Installed to sit as close to the bottom of the rear-view mirror as possible. By gently pushing down on the RD the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when you take your finger away. This can also be useful to access the release button.
STEP 1 – Loosen the clamp screw so the top section separates from the mid
section. This will provide the necessary clearance to slide the mount over the
mirror stem as shown above.
Adjust the mirror parallel to the windshield and slightly upward for Ease of
Installation.
STEP 4 – Rotate the mount so it is parallel with the bottom of the mirror. lighten the clamp screw untill the mount is securely attached to the mirror stem.
STEP 3 – When the mount is positioned as far from the ward, as it will go, tighten the clamp screw untill the Top and Mid Seasons, are slightly snug around the mirror stem. You should still be able to rotate the mount.
STEP 4 – Rotate the mount so it is parallel with the bottom of the mirror. lighten the clamp screw untill the mount is securely attached to the mirror stem.
STEP 5 – install your radar detector onto the mount. Use the adjustments shown above to adjust the RD to your desired position. We recommend adjusting the RD as close to the bottom of your mirror as you can. Be sure to tighten all adjustment screws after the adjustments are made. For the Pivot adjustment, grab the long arm of the Allen wrench for maximum leverage. You will not strip the threaded holes In the aircraft-grade aluminum.
CAUTION
DO NOT use this mount If It Interferes with the adjustability or the operation
of your rear view mirror In any way.
DO NOT use this mount If the radar detector creates an unsafe viewing
obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for
assistance.
All BlendMount products are accompanied by detailed Installation Instructions
and adjustment tips. You are encouraged to contact
customerservice@biendmount.com or
call J28 Design at 1-888-497-8388 for
further assistance.
Check the BlendMount Forum for Installation Ups and acme vehicle-specific
Installs. www.blendmount.com
Your feedback Is very Important ID us. Please email any questions or comments
you have to
customerservice@blendmount.com
Innovative Design And Precision Manufacturing
BlendMount- US PATENT# D625,580 S, 0656,811 S, 0653,980 S and other patents
pending
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>