UNI-T UT661C Pipeline Blockage Detector User Manual
- June 5, 2024
- UNI-T
Table of Contents
UNI-T UT661C Pipeline Blockage Detector User Manual
1. Introduction
Blockages and obstructions in pipelines can result in significant losses in revenue and severe disruption to operations. It is often critical to correctly identify the location of any blockages or obstructions to allow swift remedial actions to be taken.
UT661C/D can quickly locate any blockages or obstructions to avoid large scale overhaul. It is able to penetrate up to 50cm wall with accuracy of ±5cm.
2. Cautions
- Turn off the device after use.
- Pull out the probe from the pipe before clearing the pipe.
- Detecting distance may be shortened slightly for detecting steel pipe.
- If the green LEDs of transmitter and receiver are lit normally but no voice is present during detection, please replace the probe.
3. Power On/Off
Transmitter: Long press power button for 1 s to power on the device, and short/long press the same button to power off the device. The device will automatically power off after 1 hour. Long press power button for more than 1 Os to compulsively power off the device.
Receiver: Rotate the power switch clockwise until the power indicator turns on to power on the device. And rotate the power switch anticlockwise until the power indicator turns off to power off the device. The device will automatically power off after 1 hour.
4. Inspection before Use
Turn on both the transmitter and receiver, rotate the power switch of the receiver clockwise to the end and place it closer to the probe, if the buzzer goes off, it is in well-condition. If not, take off the plastic cap of the probe to check if it is broken or short circuited.
5. Detection
Note: Please hold the handle tightly and rotate the wire coil when setting out
or collecting the wire.
Step 1: Insert the probe into the pipe, extend the probe to the longest length
possible, to where the blockage is located.
Step 2: Turn on the transmitter and receiver, set the sensitivity of the
receiver to MAX by rotating the power switch, then use the receiver to scan
from the probe entrance, when the buzzer goes off strongest, mark the point
and pull out the probe.
6. Sensitivity Adjustment
Users can turn the power switch to increase the sensitivity for blockage
detection. Users can use high sensitivity position to locate the approximate
range then lower the sensitivity to precisely locate the blockage point:
Increase sensitivity: rotate the power switch clockwise; Decrease sensitivity:
rotate the power switch anticlockwise.
7. Power Indicator
- Charge the device by using standard 5V 1A charger with micro USB adapter.
- If not being used for a long time, please fully charge the device and store it in a safe location.
- It is suggested to charge the device once per half year to protect the battery of the device and lengthen lifetime.
9. Demonstration
10. Probe Replacement
11. Specification
Note: The measurement distance refers to the maximum effective distance that can be detected when there is no obstruction between the transmitter and the receiver. If there is a metal or wet object between them, the effective distance will be reduced.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>