COMNOVA AUTOPART C-3020 6 Inch Double Cab Mirror Stainless Steel Running Boards Side Step Nerf Bar Installation Guide
- June 1, 2024
- COMNOVA AUTOPART
Table of Contents
COMNOVA AUTOPART C-3020 6 Inch Double Cab Mirror Stainless Steel Running
Boards Side Step Nerf Bar
Installation & CARE
C- 3020
Tools Required
- 13mm Socket
- Ratchet
- Torque Wrench
Notes
- Read this instruction carefully before starting installation.
- Proper tools will improve the quality of installation and reduce the time required.
- If missing parts or any damage found, please take a picture, and contact us.
- Step 1:
- Locate (3) mounting positions each side.
- There are 4 mounting positions each side, we will use the 1st, 2nd, 4th.
- Clean the sealant and dirt around mounting positions.
- Remove rubber plugs and clean factory threaded inserts.
- Step 2:
- Attach bracket to the rocker panel and secure with (2) MB hex bolts, {2) MB flat washers.
- Repeat to install other brackets, do not fully tighten.
- Step 3:
- Remove {6) MB hex bolts and (6) MS flat washers behind the step bar.
- Slide mounting tracks to proper positions.
- With assista nee, lift and attach the step bar to brackets. Secure the step bar on brackets with {6) MB hex bolts and {6) MB flat washers.
- Repeat to install the other side step bar, do not fully tighten.
- Step 4:
- Tighten MS hex bolts on vehicle with 15 ft. lbs. torque.
- Adjust the step bar to level and tighten MS hex bolts with 15 ft. lbs. torque.
- After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.
Part List
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>