Shenzhen Xinhengcheng Electronics Co Ltd XHC-K077 Walking Machine Instructions
- June 1, 2024
- Shenzhen Xinhengcheng Electronics Co Ltd
Table of Contents
Shenzhen Xinhengcheng Electronics Co Ltd XHC-K077 Walking Machine
Product Usage Instructions
When there are issues with the remote control, follow these steps to troubleshoot:
- Hold the remote controller and aim it towards the screen.
- Push the Power button and hold it.
- Turn on the power switch of the walking machine.
- After 5 seconds, the machine will make a quick beep sound and display 0000.
- Press the Start button, then the screen will show the current controller code.
- Shut down the machine, then restart it.
- The remote controller is now rematched to the machine, and you can control the machine with it.
FAQ
- Q: What should I do if the remote control does not respond after following the rematching steps?
- A: If the remote control still does not respond after rematching, try replacing the batteries in the remote control with new ones. If the issue persists, contact customer support for further assistance.
ATTENTION
- When you receive or use this product, the following malfunctions may occur.
- You can troubleshoot the problem by following the steps below.
Malfunction of RemoteControl
When there are 2 or more walking pads of our brand, or a new remote control to be set, you may need to rematch the remote control to the machine by following steps:
- Hold the remote controller and aim it towards the screen.
- Push the Power button and hold it.
- Turn on the power switch of the walking machine.
- After 5 seconds, the machine makes a quick beep sound and shows “0000″.
- Press the Start button, and then the screen shows the current controller code.
- Shut down the machine, then restart.
- Now the remote controller is rematched to the machine, you can control the machine with it now.
SPECIFICATION
- Remote control No: XHC-K077
- Remote control voltage: DC 3V
- Remote control Working frequency: 433.92MHz
- Remote control Size: 120mm (L) 39mm (W) 11.8mm (H)
FCC STATEMENT
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, according to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used under the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>