Luxury Spas WS-591 Elite Series Danika 5 Person Cloud Gray Instruction Manual
- June 2, 2024
- Luxury Spas
Table of Contents
Luxury Spas WS-591 Elite Series Danika 5 Person Cloud Gray
Product Information
Specifications
- Model : LS-591
- Components : Rotating jet, button light control panel filter, stainless steel jet, air adjustor, air jet, water separate device, LED light
- Additional Options : Stairs and spa covers
Product Usage Instructions
Cleaning and Maintenance
To clean and maintain the hot tub, follow these steps:
- Move out the cover.
- Pull out the skimmer basket.
- Take out any debris and clean the components thoroughly.
- Refer to Fig 1 for drainage instructions.
Filter Cleaning
- Remove the cover and pull out the skimmer basket.
- Thoroughly clean the filter with water.
- Ensure all parts are cleaned properly.
Water Controls
The hot tub features various water controls including air pump, water pump 1, water pump 2, and filter pump. To operate:
- Turn on water pump 1 by rotating the control panel counter-clockwise.
- Turn on water pump 2 by rotating the control panel clockwise.
- Activate the filter pump to spray water accordingly.
Troubleshooting
If you encounter any issues with the hot tub components, refer to the troubleshooting section in the manual for solutions.
FAQ
- Q: How often should I clean the filter?
- A: It is recommended to clean the filter regularly, ideally every 1-2 weeks depending on usage.
Thank you for your Luxury Spas purchase. To ensure that you use this product safely and effectively, please read this installation and operation manual carefully before use.
Before Using
- Check to make sure the drain cap located in the lower corner of the spa base is tight and secure before filling the spa with water. You may attach an optional drain hose to the drain connection to drain water away from the spa. (Fig.1)
- Ensure that the spa is connected to the correct electrical power. The electrical power requirements are listed under the Technical Specification section of this manual.
- Before turning on the water pump, remove the filter from the skimmer basket to remove the plastic protective wrapping and place it back in the skimmer basket. Make sure the water level is a minimum of 1 inch over the top jets. Do not turn on water pump, heat pump or air bubble pump without water. |
- People with medical conditions such as hypertension or heart disease should not use this product. Minors should only use the spa under adult supervision only. Consult a physician if you are unsure whether the spa is safe to use.
- Adjust the water temperature to your desired temperature setting using the heater button on the user keypad. The included user keypad manual provides instructions on how to operate the spa controls.
- Make sure that slip-resistant steps are used to enter and exit the spa being careful to avoid slipping
Technical Parameters
- Size : 87″ x 74″ x 36″
- Voltage: 220-240V 50Hz/60Hz
- Power of water pump : 1500WX 1
- Power of water pump : 2200W X 1|
- Filter pump : 250W
- Power of heat pump : 3000W
- Power of air pump : 400W
- Total Power: 7350 Watts
Cleaning and Maintenance
- Test your water chemical balance 2-4 times per month. Adjust the water balance with the appropriate hot tub chemicals. Use the recommendations listed in the included Cleaning and Maintenance guide to ensure the sanitizer levels. Keep a water test log track your test results and make notes on adjustments.
- Clean the spa filter every 2 weeks and replace it annually. The spa filter is located under the skimmer basket. Remove the skimmer cover to locate the filter to clean or replace it. The water filter cartridge should be replaced when flow is noticeably reduced. We recommend cleaning the spa filter every 2 weeks. To clean the filter, remove any large debris from the filter. Use a water hose to spray any smaller debris from the filter. Soak the filter overnight in a 5-gallon bucket full of water and a spa filter cleaner that can be purchased at your local pool and spa supply store.
- Replace your spa filter approximately every 12 months. Change the spa filter every 12 months or every 15 cleanings. Keep track of your spa filter’s age and/or cleaning cycles. Keep the spa clean by draining it and refilling it every 3-4 months. While the hot tub is drained, conduct a full cleaning of all surfaces, the waterline, and plumbing. Do NOT use any household cleaning products or soaps. Choose a quality hot tub specific cleaning product to keep out phosphates, nitrates and other contaminants that can negatively affect water quality. For accumulated dirt and debris, vacuum seats and floors with a small vacuum made specifically for spas and hot tubs. Floating debris can be removed with a simple skimmer net.
- Air out the spa cover twice per week. To increase the longevity of your spa cover remove it every couple of weeks, flip it upside down, and allow it to breathe. Cleaning and condition your spa cover with a vinyl spa cover cleaner. Using a spacover cleaner can quickly remove airborne oils, dirt, tree sap, and pollen. After it’s clean, use a cover conditioner to replenish the vinyl plasticizers that keep your vinyl spa cover soft, strong and looking great.
- Add fill water to your spa. The water level in the spa should be in the middle ofthe skimmer intake or a little higher. You don’t want it too high, and you never want to overflow the spa, so keep a close eye on the water level fuhig. Do not operate the spa without the proper water level or it will damage the spa pump.
If you have additional questions on maintaining your new Luxury Spas hot tub, please contact us at 866.220.7405.
Troubleshooting
Filter Cleaning
Hot Tub Components
Water controls
Turn on water pump 1, water will spray from
Turn on water pump 2
- The position will spray once when the water separator device is rotated counter-clockwise.
- The position will spray once when the water separator device is rotated clockwise.
Turn on the filter pump, water will spray from
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>