frozzy TL110 Mobile Fridge User Manual
- May 15, 2024
- frozzy
Table of Contents
TL110
MOBILE FRIDGE
Eldom Sp. z o.o. • ul. Pawła Chromika 5a • 40-238 Katowice, POLAND
tel: +48 32 2553340 • fax: +48 32 2530412 •
www.eldom.eu
TL110 Mobile Fridge
The disposal of used electrical and electronic equipment (applies to European
Union countries and other European countries with separate waste-collection
systems).
This symbol on the product or its packaging indicates that it should not be
classified as household waste. It should be handed over to an appropriate
company dealing with the collection and recycling of electrical and electronic
equipment. The correct disposal of the product will prevent potential
negative consequences for the environment and human health resulting from
hazardous substances present in the product. Electrical devices must be handed
over to restrict their re-use and further treatment. If the device contains
batte ries, remove them, and hand them over to a storage point separately. DO
NOT THROW EQUIPMENT INTO THE MUNICIPAL WASTE BIN. Material recycling helps to
preserve natural resources. For detailed information on how to recycle this
product, please contact your local authority, the recycling company, or the
shop where you bought it.
SAFETY INSTRUCTIONS
Read thoroughly this manual before the first use of the unit.
Failure to comply with the following safety and safety instructions may result
in electric shock, fire and/or serious injury.
Keep all warnings and security notices so you can use them in the future.
-
BEFORE inserting the plug into the socket, MAKE SURE that the data on the appliance’s rating plate corresponds to the power supply specifications.
-
Do not pull the cord to remove the plug from the socket.
-
Do not cover the ventilation openings on the cover when the appliance is in operation.
-
Do not change the power mode while the appliance is in operation, this risks damaging the appliance.
-
Do not expose the product to direct sunlight, rain, snow, excessive moisture, etc.
-
The power cord must not be close to heat sources.
-
Use the handle to carry the refrigerator.
-
Close the lid gently using the handle on the front of the lid.
-
Do not bend the lid too tightly, there is a risk of mechanical damage not covered by the warranty.
-
Use only in upright position, do not place the refrigerator “upside down”.
-
Do not overload the refrigerator. The lid must close freely.
NOTE also that products must not cover the fan opening in the lid from the inside. -
Take special care when transporting the switched-on appliance by car. Protect against falling while driving.
-
This equipment may be used by children of at least 8 years of age and by people with reduced physical and mental capabilities and lack of experience and knowledge of the equipment if supervision or instruction is provided on how to use the equipment safely so that the associated risks are understood. Children should not play with the equipment.
Unsupervised children should not carry out cleaning or maintenance of the equipment. Keep the equipment and its cord out of the reach of children. -
Disconnect the appliance from the power supply before cleaning.
-
The appliance is intended for domestic use only.
-
Use only with the originally supplied accessories.
-
Do not use the refrigerator with a damaged power cord.
-
If the power cord becomes damaged, it must be replaced at the Manufacturer’s Service Centre to prevent danger. List of services in the appendix and at www.eldom.eu.
-
Repairs to the equipment may only be carried out by an authorised service centre. Any modernisation or use of other than original spare parts or components of the appliance is forbidden and endangers the safety of use.
-
Eldom Sp. z o. o. Company shall not be held liable for any damage resulting from improper use of the device.
WARNING: PLASTIC BAG CAN BE DANGEROUS, TO AVOID DANGER OF SUFFOCATION KEEP THIS BAG AWAY FROM BABIES AND CHILDREN.
-
ENVIRONMENTAL PROTECTION
− The appliance is made of materials which can be recycled.
− It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. -
WARRANTY
− This appliance is designed for domestic use only.
− It cannot be used for professional purposes or for other than the intended use.
− Improper use will nullify the guarantee.
GENERAL DESCRIPTION
- Handle
- Control panel
- Power supply panel
- Ventilation openings
- Cover
- Body
- Power cord 12V (automotive)
- Power cord 220-240V
A. ECO switch
B. On/Off switch
C. Display
D. Control buttons
E. AC power socket
F. DC power socket
G. USB socket
DANE TECHNICZNE
− Power for 12V power supply:
- cooling: 45W
- heating: 43W
− Power for 220-240V:
- cooling: 60W
- heating: 55W
- ECO: 8,6W
− Supply voltage:
- 12V lub 220-240V~ 50Hz
- USB: 5V, 2A
− Storage capacity: 26l
INTENDED USE
The TL110 travel fridge combines dual, integrated cooling and heating functions through the use of a semiconductor (Peltier cell), without the use of a compressor or cryogenics. Among the product’s advantages are its eco- friendliness, small size, negligible weight, long service life and low energy consumption.
The TL110 travel fridge is not a complete replacement for a stationary
domestic fridge.
It operates with a different cooling technique and under varying external
conditions, and therefore the parameters, operation and performance of the two
products are not comparable. The unit cools to a maximum of 15°C below ambient
temperature. It heats to a temperature of approximately 60°C.
For optimum cooling effect, it is recommended to insert unfrozen products.
Cooling will take between 2 and 3 hours.
The appliance is not designed to reheat cold products, but to keep hot
meals at a high temperature.
If the appliance is operated correctly and according to the instructions, the
temperature of the products can be maintained for many hours.
The handle (1) protects the lid from opening. Opening the lid (5) is only
possible when the handle is folded down.
OPERATION
After unpacking the device, make sure that it has not been damaged in transit.
If in any doubt, refrain from using it until you contact a service center.
The unit can be powered by 12V or 220-240V, using the supplied power cables
(7) and (8), without additional accessories.
NOTE
Do not connect two power cables at the same time – this may damage the
appliance and invalidate the warranty.
Do not cover the ventilation openings when the unit is in operation
NOTE
The value set with the “D” buttons does not represent the set temperature. It
only indicates the intensity level of the unit. The value of the temperature
reached by the appliance depends, among other things, on the value of the
outside temperature and the quantity and temperature of the products placed
inside.
220-240V AC POWER SUPPLY
− Place the unit on a flat and stable Surface.
− Connect one end of the power cord (8) to the “E” socket and the other end to
the mains socket.
− Switch the unit on using the “B” button. The display “C” will show the
temperature value inside the appliance.
− Use the “D” buttons to set the operating mode (positive value – heating,
negative value – cooling) and the intensity level.
− Optionally, the ECO function can be activated using button “A”.
The ECO function only works with a 220-240V power supply. Current consumption
is reduced in this case. The ECO function can be used, for example, when
storing small quantities of food.
220-240V AC POWER SUPPLY
− Place the unit on a flat and stable Surface.
− Connect one end of the power cord (8) to the “E” socket and the other end to
the mains socket.
− Switch the unit on using the “B” button. The display “C” will show the
temperature value inside the appliance.
− Use the “D” buttons to set the operating mode (positive value – heating,
negative value – cooling) and the intensity level.
− Optionally, the ECO function can be activated using button “A”.
The ECO function only works with a 220-240V power supply. Current consumption
is reduced in this case. The ECO function can be used, for example, when
storing small quantities of food.
USB socket 5V, 2 A
− is used to charge devices.
• Recommendations
− store foodstuffs in their own packaging to prevent the direct effects of
frosting or condensation and the permeation of odours,
− in the case of vehicle power supply, do not operate the refrigerator from
the power socket when the vehicle is stationary (engine switched off).
− in the case of car power supply, do not operate the fridge from the
cigarette lighter socket for more than 3 hours when the car is not in use (the
car engine is switched off) – prolonged operation leads to excessive battery
discharge,
− a change of temperature in the insulated container (frequent opening or
switching off) leads to natural phenomena in the form of frost or condensation
visible on the walls of the container or the inside of the lid, as well as
directly on the foodstuffs,
− the optimum temperature inside the insulated container, while maintaining
certain constant external parameters, is usually reached between 2 and 4 hours
after the appliance has been in operation.
− the appliance is not designed to cool warm or hot foodstuffs.
CLEANING AND MAINTENANCE
− Before carrying out any maintenance or repair work, switch off the appliance
and disconnect it from the power supply.
− Clean the housing, fittings and power cord with a soft, slightly dampened
cloth with a little dishwashing detergent.
WARNING: Do not immerse the appliance in water.
− Do not use any harsh cleaning agents for cleaning cause damage to the
surface of the housing.