Saintlark K30 Portable Speaker User Manual
- May 15, 2024
- Saintlark
Table of Contents
Saintlark K30 Portable Speaker
Product Introduction
Pairing Mode:
- When the host is powered on, short press the M. key to switch to the UHF mode, and long press the M key for 3 seconds to hear the tone of “UHF waiting for pairing”
- Turn on the microphone, briefly press the power button to switch the frequency point, and then long press the paining button to enter the pairing state. When you hear the tone of “wireless pairing”. the pairing is successful.
Specifications
OutpJt Power
|
‘->60W
|
Frequency Range
| 60HZ-20KHZ
---|---|---|---
BattEry Model
|
7.4V/4DOOmAh
|
VVaterproot
|
lpx4
Cl1argirig Voltage
|
DC5V=LA
|
Bluetooth
|
“’10rn
Cl1arging Time|
“‘5hours
|
Play Time
| “‘3.5hour-s
Instructions
- Power on: Press the power button for 3-4 seconds.
- Power off: Press the power button for 3-4 seconds.
- Bluetooth match: The device automatically enters Bluetooth pairing mode upon startup. Press M to switch to other modes. Long press the Play button to disconnect Bluetooth pairing.
- Mode switch: Press M to switch between BT/USB/TF/AUX.
- Wireless mode: Press M to switch.
- Wireless pairing: Press M to switch to wireless mode and long press M for pairing.
- AUX mode: Insert the AUX cable to switch automatically, and press the M key to switch other modes.
- TF mode: Insert TF card and switch automatically. Press M to switch other modes.
- U disk mode: Insert U disk and switch automatically. Press M to switch other modes.
- Play/pause: Press the play/Pause button.
- Previous: Short press the “-” key
- Next: Short press the “+” key
- Volume+: Long press the + button
- Volume- Lona press the – button
- Pause/play/mute: Short press Pause button (AUX mode is mute function)
- In charge: Plug in Type-C Charging Cable (5V 2A)
- Charge completion: Full charge red LED light off
Application Notice
- In order to achieve the best effect of microphone sound reinforcement, please place the microphone 1-2cm in front of the mouth and aim at the microphone to pronounce. If there is a howl, you can appropriately reduce the volume or slightly extend the distance between the machine and the microphone to prevent mutual interference;
- Try to avoid plugging and unplugging the microphone socket frequently to avoid loose socket and poor contact. Do not plug the microphone and sound source incorrectly:
- To ensure the service life of the lithium battery, it is recommended to recharge after use. Frequent charging will accelerate the aging of the battery chip. If it is not used for a long time, it should be charged every two months:
- Due to the strong magnetism of the horn, it is not allowed to put the machine and bank card and other magnetic things together to avoid unnecessary trouble caused by magnetic loss:
- All parts of this product are designed according to the working requirements of this machine. If you need to replace parts, try to use our original parts to achieve the best working condition;
- This product may become slightly hot during charging and normal use, which is a dry normal phenomenon;
- Please use an anti-static soft cloth to clean this product. Please turn off the power switch and disconnect all external connections before cleaning this product. Do not wipe with chemical substances (such as alcohol, benzene and other chemical lotions or abrasive cleaning agents):
- Do not drop, throw or step on this product. Do not disassemble this product without authorization, or you will not enjoy our free warranty service.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party. Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices). This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Safety
Safety Caution
- Do not put the product and accessories near the fire source or any overheated environment.
- Do not touch the product and accessories with water and moisture, do not use the equipment near water, and do not immerse the product in any liquid to prevent the product and accessories from being subjected to water drops or splashes.
- Do not open or disassemble or repair the battery module by yourself. If the battery is replaced improperly, there will be an explosion hazard. Do not put the battery into water, fire or any overheated environment.
- This product is used after being charged by an external power adapter (5V-2A). After charging, it can be conveniently disconnected from the power grid by unplugging the power adapter plug.
- When the user does not use this product temporarily, please turn the power switch of the product to the off state to turn off the power (see the product control diagram to avoid the loss of battery power.
- When the use of wireless devices is prohibited or the use of devices will cause interference and security risks to electronic devices, please turn off this product.
- In flammable and explosive areas, please close this product and follow the relevant instructions to avoid bow explosion or fire. Flammable and explosive areas include, but are not limited to, gas stations, transportation and storage facilities for flammable or chemical products, areas with explosion hazard signs, and areas with the sign “Turn off two-way radio equipment’.
- Please abide by the relevant regulations and rules of the airline when taking the plane, and close this product before the plane takes off to avoid potential safety hazards.
- It is only suitable for safe use in non-tropical climate conditions and in areas below 2000 meters above sea level.
SHENZHEN SAINTLARK TECHNOLOGY CO.
Hang on, Boding an Doing biennial Park.
- Tel. 400 998 3038
- www.saintlark.com