Aeropost T-Bar Ladder Roof Hook Ladder Standoff with Wheel and Grip Instruction Manual
- May 15, 2024
- Aeropost
Table of Contents
ROOF LADDER HOOKS
INSTRUCTIONS
T-Bar Ladder Roof Hook Ladder Standoff with Wheel and Grip
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. Pay attention to safe operating requirements, warnings and precautions. Use this product correctly and carefully to achieve its intended purpose.
WARNING: Always use BOTH Roof Ladder Hooks with a compatible ladder.
Never use only one Roof Ladder Hook.
WARING: This product, as a ladder accessory, is to be used only for
supporting ladders on pitched roofs or gutter edges. Do not use this product
on its own or as an extension to a ladder that is vertical or hanging freely
from a ledge.
SAFETY INSTRUCTIONS
DANGER! Keep ladders and their exposed metal parts away from power lines
to avoid the risk of electric shock.
WARNING! Do not use the equipment if you are in poor health or under the
influence of medication, alcohol, or drugs to ensure safe operation.
WARNING! Always adhere to the safety instructions and warnings provided
with any ladder used in conjunction with the roof ladder hook kit.
WARNING! Familiarize yourself with application, limitations, and
potential hazards of roof ladder hooks to prevent the risk of injury.
WARNING! Before using this product, conduct a thorough inspection to
ensure the equipment is in good condition. DO NOT use it if any parts are
damaged or missing.
WARNING! Always assess the work area before placing a ladder. Ensure the
surface is safe and free from obstacles or hazards.
WARNING! Check the ladder hook before each use. Ensure all fastening nuts
and bolts are securely tightened before attempting to climb the ladder.
WARNING! Before climbing the ladder, make sure the hook is firmly fixed
on the roof ridge or on the edge of the gutter.
DO NOT overreach while on the ladder.
DO NOT exceed the rated capacity of the ladder hooks.
Keep children or unauthorized personnel away from the work area.
DO NOT use corrosive agents for cleaning the product.
When not in use, store this tool carefully in a safe, dry location out of the
reach of children.
PRODUCT FAMILIARISTION
No. | Name | Quantity | Description/Remark |
---|---|---|---|
1 | Main Hook | 1 | Comes with 5 mounting holes. Applicable ladder pipe range: |
D0.79-1.77in.
2| Corner Bracket 1| 1| Place it under the Main Hook.
The straight handle part is assembled with the Main Hook and Second Hook.
3| Second Hook with fixed Wheel| 1| Place it above the Main Hook. Wheel faces
up.
The straight handle part is installed with the Main Hook and Corner Bracket 1.
The width can be adjusted from 10 to 18.9″.
4| Corner Bracket 2| 1| Comes with 10 mounting holes. Place it under Corner
Bracket 1.
The arc part is assembled with Corner Bracket 1, 5 angles adjustable.
5| Support Hook| 1| Assemble with Corner Bracket 2. Adjust the support angle
as needed.
6| M6 Bolt (Small)| 2| Pass the bolts through the overlapping parts of the
Corner Bracket 1+2.
See Figure 2 for the stacking sequence of bolt washers, and then tighten the
nuts.
7| M6 Nut (Small)
8| M8 Bolt| 2| Pass the bolts through the overlapping parts of the Second
Hook+ Main Hook+ Corner Bracket 1.
See Figure 2 for the stacking sequence of bolt washers, and then tighten the
nuts.
9| M8 Nut
10| M8 Bolt| 1| Pass the bolts through the overlapping parts of the Corner
Bracket 2+ Support Hook. See Figure 2 for the stacking sequence of bolt
washers, and then tighten the nuts.
11| M8 Nut
ASSEMBLY AND USE