SEMANEY 2024 Kitchen Faucets User Manual
- June 17, 2024
- SEMANEY
Table of Contents
Kitchen Faucets
Thank you for choosing our product.
Please read carefully the following installation instructions in order to
avoid component damage or injury to the installer.
Keep the installation manual available for future maintenance or reference.
** PRECAUTIONS: Folow ail safety precautions to avoid bodily injury or
damage to property.
Notice**
**** PRECAUTIONS| 1.Cleaning
Before installation, shut off the water supply valves and clean up the water
supply system.Clean the area of the mounting holes before installation.
---|---
2.Mounting hole
Make sure the mounting hole size is between φ33mm-φ35mm as shown in the
diagram.
3.Parameter
Water pressure: Min: 0.05MPa Max: 0.75MPa
Temperature of water supply <65C°
Working Temperature=0 C°
Includes
- Faucet
- Mounting hardware: nut, metal washer, rubber washer
Maintenance
-
Operate the faucet gently in order for a sustainable use.
-
Always blot dry any water from faucet surface. Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet.
To remove water spots, please apply warm water and a damp soft cloth. Make certain to rinse thoroughly with water immediately after cleaner. -
Although the finish is extremely durable, it can be damaged by some cleaners. Do not use detergent powder, polishing powder, granular detergent or nylon brush to clean.
-
Do not use acidic detergents. if happened, it must be rinsed properly and wiped dry with a soft cloth.
-
When the air temperature is below 0 C°, a measure should be taken to keep the faucet working condition warm.
-
Shut off the water supply valves when the faucet will not be in use for an extended amount of time.
-
We reserve the right to make revisions in the design of products without notice.
Installation Steps
-
Take the faucet out of the packing box, and
A. For 1-hole sink, fit the faucet to the mounting hole on the sink, as shown in diagram 1A.
B. For 3-hole sink, insert deck plate over the hoses in the mounting shank, and then mount the faucet on the sink,as shown in diagram 1 B.
-
Slide the rubber gasket first, the metal washer second, and then the mounting nut over the hoses onto the shank and hand tighten them firmly, as shown in diagram 2.
-
Connect the hot & cold supply lines onto the matching water valves and secure the connection with an adjustable wrench, as shown in diagram 3.
-
Turn on the water valves then the faucet Run the water flow for 15 seconds to clean up the lines and check for any leaks, as shown indiagram 4.
-
Test the water running, and make certain of the faucet sprayer changes between stream and spray properly, as shown in diagram 5.
Company: Jiangmen Yanyi E-Commerce Co., Ltd.
Address: shuikouzhenxiangyangcunweihuigongyequ
2haozhi3,kaiping,Guangdong CHINA
Email: yanyi-jm@outlook.com
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>