ROADER 2021 Bronco Front and Rear Roll Bar Grab Handles Instruction Manual
- June 17, 2024
- ROADER
Table of Contents
ROADER 2021 Bronco Front and Rear Roll Bar Grab Handles
Installation & Use Instructions
Grip Grab Handles For Ford Bronco 2021+
- Front Grab Handles (x2)
- M8X40 Screw (x4)
- Rubber Mat a (x2)
- Rubber Mat b (x2)
- Allen key(x1)
- Rear Grab Handles (x2)
- M8X40 Screw (x4)
- Rubber Mat a (x2)
- Rubber Mat b (x2)
-
Step 1: Find the front and rear seat screw holes and remove them.
(Note: The middle screw does not need to be disassembled.)
-
Step 2: The short handle is used in the front seat.
The long handle is used in the rear seat. -
Step 3 : Determine the direction of installation.
-
Step 4 : Align the handle and screw fittings with the original car holes.
(Note: Use the rubber mat a to install in front of the handle, and use the rubber mat b to install it behind the handle.)
-
Step 5: Tighten the screws. Complete the installation of the handles.
If you have any questions about product quality or installation, please be sure to contact us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>