VOXELPLA Bento Box 2 Stage Filter with HEPA and Activated Carbon Instruction Manual
- June 17, 2024
- VOXELPLA
Table of Contents
THE MOST RELIABLE FILAMENT ON EARTH
Bento Box 2 Stage Filter with HEPA and Activated Carbon
Step 1
Insert the two fans into the fan cover and feed the cable through the holes –
make sure the sticker on the back of the fan is facing the two
holes.
Step 2
Organize the cables from both fans to either the left or right hole on the fan
duct.
Black Fan Duct is for the Voron and the Red is for the Bambu Lab
printers.
Step 3
Screw in the four screws included in the kit as shown below.
Step 4 (Only
for Bambu Lab Printers)
Attach the Bento Box on the L-shape plastic on the right back of the
printer.
Step 5 (Only
for Bambu Lab Printers)
Route the fan cables to the hole on the left back of the machine; the whole
goes out of the bottom of the machine.
Step 6
Unscrew the power supply terminal and insert the two red wires to the positive
terminal and two black wires to the negative terminal – then screw the
terminal in tightly – pull on the wires to make sure it is secured.
Step 7
Plug in the power supply to the wall; make sure the two fans are spinning, and
reattach the rest of the bento box, as shown below.
Make sure to put the HEPA filter inside the WHITE HEPA compartment. You might
not feel much air coming out of the vent, and the fan duct was designed to do
just that. The duct is designed to disperse the air and not introduce air
currents that might cool down your print and cause warping.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>