CARTER-HOFFMANN CD260H Enclosed Rotary Dish Carts Instructions
- June 17, 2024
- CARTER-HOFFMANN
Table of Contents
Enclosed Rotary
Dish Carts CD260H & CD252H
CD260H Enclosed Rotary Dish Carts
Cleaning, Operating, Maintenance Insiructions, Paris List & Warranty
Since 1947, Foodservice Equipment Th Delvers!
NOTE:
This equipment has been designed and manu-factured to meet all applicable
bealth and safety codes and will give years of dependable service if used
properly. All carts should be thorougbly cleaned before using.
CAUTION
Cleansers, detergents, degreasers, sanitizers, or bleaching agents thut
contain chiorides or phosphates will cause permanent damage to stainless steel
products.
The damage appears as pits, eruptions, voids, small holes, cracks, severe
discol-oration, or dulling of the metal finish.
Water with high chloride content can also damage stainless steel. If unsure of
your water quality, we recommend i you have it tested. THIS DAMAGE IS
PERMANENT; COSTLY TO REPAIR, AND IS NOT COVERED BY THE WARRANTY.
Cleaning Instructions
WARNING
Be sure the cabinet is unplugged and cool before cleaning.
The heater should not be exposed to direct contact with water or cleaning
sprays. Permanent damage to the promical components will resuls
-
To clean stainless steel surfaces use only cleansers, detergents, degreasers, or sanitizers that are certified to be “chloride-free” and “phosphate-free;” and cleansers, degreasers, or sanitizers only in the recommended concentrations. DO NOT exceed recommended concentrations or mixing ratios. After cleaning and sanitizing, rinse all exposed surfaces thoroughly with large amounts of clear water.
Wipe off any standing liquid or residue from all horizontal surfaces in corners, or near edges. -
If applicable, vinyl trim or laminate should be washed with a chlorine-free detergent and water. Rinse thoroughly with clear water and allow to dry. Never use abrasive cleaners, waxes, car polish or substances containing strong aromatic solvents or alcohol. Caution: When using solvents, it is essential that proper precautionary measures be observed.
Refer to solvent manufacturer’s instructions. Use of direct steam/hot water cleaning at temperatures above 190°F may result in “bubbling” or loosening of vinyl adhesive.
RECOMMENDED “TIPS” FOR CLEANING STAINLESS STEEL
| Purpose | Frequency | Cleaning Agent | Method of Application |
|---|---|---|---|
| Routine cleaning | Daily | Soap, ammonia detergent and water | Sponge with cloth, |
rinse with clear water and wipe dry.
Smears/ fingerprints| As Needed| Stainless steel cleaner or similar products|
Rub with cloth as directed on package. Rub in direction
of grain of stainless steel. Do not use on vinyl trim.
Stubborn spots and stains| Daily As Needed| Any chloride-free or phosphate-
free cleaner| Apply with damp sponge or cloth. Rub in direction of polish
lines. Rinse thoroughly after use, especially if cleaner contains chlorine
bleach. Do not use on vinyl trim.
Hard waterm spots| Daily As Needed| Vinegar| Swab with cloth. Rinse with water
and wipe dry.
CAUTION Do not use steel wool pads as they will result in rusting from the ferrous metak in the pads.
Electrical Requiremenis Specifications
Operates on 120 volt, 60 HZ, 1 PH, 1400 watts, 11.7 amps, 8 foot power cord with NEMA 5-15P plug.
[A] CASTERS
5″ diameter, all swivel, polyurethane tread. Sealed Delrin bearing and double
ball bearing swivel. Zerk grease fittings. Plate mounted and bolted to base.
Two casters fitted with breaks.
[B] DOORS
Full length, double panel stainless steel construction with interior cavity
filled with 1″ fiberglass high-density insulation.
[C] LATCHES
Flush mounted heavy-duty sliding latch for positive door closing.
[D] HINGES
Concealed, all stainless steel 12 gauge butt type hinge with 3/8″ diameter
fixed pin.
[E] HINGED COVER
All stainless steel removable cover and lift handles. Center piano-type hinge
permits cover to open for easy loading/unloading. Notched top cover allows
front door to open even when top cover is closed.
[F] CORD WRAP_(cD252H, CD260H)
Keeps cord safely out-of-the-way when moving the cart.
Heater System
Operating Instructions
WARNING
Do not plug into ungrounded receptacle.
Check to ensure that beater plug is in safe operating condition.
-
Plug the cabinet in and allow 45 minutes for preheat.
-
For best resulis load dishes into the cart as quickly as possible.
Door/lid should be opened only when necessary in order to help keep the dishes at proper temperature. -
Take care to avoid bumping carts into doors, walls, obstructions, etc.
High density 1400 watt inconel sheathed heating element. High impedance protected externally cooled fan motor with self-lubricating bearings.
The thermostat adjustment is located underneath the cabinet (load side) on the right side of the electrical housing. To increase the temperature, turn the knob to the right. To decrease the temperature, turn the knob to the left.
Maintenance Instructions
[A] CASTERS
Some casters are equipped with Zerk grease fitting so that they may be easily
lubricated with a grease gun. Recommended lubrication is at least once every
six months. Lubrication will be required more often if carts are cleaned with
a hot water or steam cleaning system. Casters with special bearings are
recommended for frequent cart wash or steam cleaning situations.
[B] LATCH
Check frequently to insure that the door latch is secure. Latch may become
“sticky” due to residue buildup from daily use and cleaning.
Lubricate latch regularly with WD-40, silicone spray, graphite or other
commercial lubricants for stainless steel products. Do not use oil.
[C] PERIMETER BUMPERS
If applicable, vinyl which has been dislodged from the channel due to severe
bumping or scraping can be pried back into place with a common screwdriver.
Replacement Parts
Contact factory with your model and serial number for replacement cart
components. If your model is not listed, please contact factory for listing of
parts.
WARNING
Use only (OEM) original equipment manufacturer replacement parts.
Using unauthorized parts may cause serious injury. Replacement parts should be
installed by a qualified service technician.
| Item | Part Number | Description |
|---|---|---|
| 1 | 18605-0010 | |
| 18605-0015 | Power Cord With Plug, 120 Volt |
Power Cord With Plug, 220 Volt
2| 18600-0031| Thermostat
3| 18612-0030
18612-0040| Heat Element 120 Volt 1400 Watt
Heat Element 220 Volt 1400 Watt
4| 18603-0092
18603-0093| Blower Motor 120 Volt
Blower Motor 220 Volt
| 18302-0332| Door Latch
| 18304-0226| Hinge
*| 16090-8157| Turntable Assembly
Wiring Diagram
CD252H & CD260H—11000-0723 
Carter-Hoffmann Corporation Warranty:
Carter-Hoffmann Corporation (“CARTER-HOFEMANN’) warrants to the initial
purchaser of tts standard Carter Line Products that CARTER-HOFPMANN will, at
its option, repair or replace, during the warranty period set forth below, any
part of such products made necessary due to a defect in material or
workmanship which ts present when the product leaves tts factory and which
manifests itself during the warranty period under normal use and service.
This warranty applies only to original equipment owned and possessed by the
initial purchaser and the warranty period begins on the date of original
shipment from the CARTER-HOFRMANN factory and extends as follows: to
electrical and refrigeration components for one year; to electrical and
refrigeration labor for 120 days; to refrigeration compressor unit for 1 year
(limited to replacement of the unit only—not to include labor for removal,
repair or replacement), and to all other component parts and labor for 12
months.
Repatr or replacements under this warranty will be performed, unless otherwise
authorized in writing by CARTER-HOFFMANN, at tts factory. All parts or
components to be repatred or replaced under this warranty are to be sbipped
prepaid to CARTER-HOFFMANN, with reimbursement credit for such part or
component to be given if found by CARTER-HOFFMANN to be defective.
CARTER-HOFFMANN neither makes nor assumes and does not authorize any other
person to make or assume any obligation or liability in connection with tts
products other than that covered in this warranty. This warranty applies only
within the continental United States and Canada. In Alaska and Hawaii, this
warranty applies onty to and is limited to the supply of replacement parts.
Warranty Exclusions And Limitations:
Any implied warranty of merchantability or fitness for a particular purpose ts
bereby spectfically disclaimed by Carter-Hoffmann Corporation. There are no
warranties, expressed or implied, which extend beyond ihe description on the
face hereof: This warranty does not cover and CARTER-HOFFMANN shall not under
any circum-stances be liable for any incidental, consequeniial or other
damages (such as infury to persons or property, loss of time, inconvenience,
loss of use, loss of business or profits, or other matters not specifically
covered) arising in connection with the use of, inability to use, or failure
of these products.
Specifications subject to change through product improvement and innovation.
Printed in U.S.A.
1551 McCormick Avenue, Mundelein, lllinois 60060
CARTER-HOFFMANN
Tel. 1-800-323-9793
Fax No. 847-367-8981 18400-3033
Sice 194 Fodenice ipoan The Delerst
SEPTEMBER 1997
SN/97P0865
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>