HeatPumps4Pools iFlo Junior Sand Filter and 0.33hp Pump Instructions
- June 4, 2024
- HeatPumps4Pools
Table of Contents
HeatPumps4Pools iFlo Junior Sand Filter and 0.33hp Pump
IFLO JUNIOR INSTRUCTIONS
What is in the box
- Pump
- Pump fittings (smaller bag, two O-rings, two threaded hose tails, clear lid)
- Multiport valve
- Filter Tank, clamp, filter insert for laterals, and flex pipe.
- Filter fittings (large bag with three threaded hose tails with O-rings, six laterals, large MPV O-ring, two rubber inserts, pressure gauge in small box, drain valve assembly)
- Main base and booklets
- Insert laterals with the notch facing
- 12 o’clock as the photo shows, twist clockwise to lock in place. (photo shows locked below) You can do the first one outside the rest will have to be inserted inside the tank. (as shown below)
- Split the drain valve assembly ensuring that there is a gasket on each side as shown.
- Insert the threaded section through the designated hold thread facing out as shown above and tighten.
- Loosen and remove the clamp collar as shown. You can now insert your sand guard that stop sand going down into the laterals and fill the tank with sand. Remove the sand guard and place to one side.
- Place the largest O-ring over the base of the MPV and slide up to the top so that it creates a seal on the unit. It will not hurt to apply some O-ring grease to any of the O-rings in this installation and is recommended to lengthen the life of your O-rings and prevent leaks.
- You can now place the collar on and tighten to seal between the MPV and tank body.
- Grease O-rings in hose tails and screw in to the MPV as above.
- These are the two holes you will be fixing your pump down to with the butterfly nuts.
- Tighten and secure the pump to the base.
- Remove the plug photographed in hand and insert the pressure gauge as shown. The plug can be put to one side with the sand guard. They are no longer required, but handy to keep.
- Push in the rubber collar into your flex hose on each end, this will be linking the filter to the pump.
- Push into the hose tail marked pump.
- In your smaller bag take the larger O-ring and place in the designated slot where the lid will screw on.
- Take the smaller and insert in the outlet side in the designated slot.
- Greece O-rings and screw the hose tail into the outlet of the pump.
- Place the clear on and screw tight, then repeat screwing the hose tail on. Note if you want a ridged pipe installation you will have to buy separate unions.
- Now place the other end of the flexible hose over the outlet pump hose tail. The clear side is ready to be connected to the pool.
- Secure both ends of the flex pipe into position using the hose clamps provided. Not shown in the image.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>