Tongxinyue JH75-5D Toy Car Instruction Manual

Tongxinyue JH75-5D Toy Car

Product Information

The Engineering Vehicle is a remote control vehicle designed for engineering purposes. It is equipped with a remote control that requires 2 pcs of AA batteries for operation.

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the regulations set by the FCC (Federal Communications Commission).

Reorient or Relocate the Receiving Antenna
To improve the signal reception, it is recommended to reorient or relocate the receiving antenna. Increasing the separation between the equipment and the receiver can also help enhance the signal quality.

Power Connection
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. This will help prevent any interference between the equipment and the receiver. If you need assistance, consult a dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. It can be used in portable exposure conditions without restriction.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Product Usage Instructions

Battery Installation

1. Locate the battery compartment on the remote control.
2. Open the battery compartment by sliding the cover in the direction indicated.
3. Insert 2 pcs of AA batteries, following the polarity markings inside the compartment.
4. Close the battery compartment securely.

Remote Control Operation

1. Ensure the Engineering Vehicle is powered on and in range of the remote control.
2. Hold the remote control firmly in your hand.
3. Use the buttons or controls on the remote control to maneuver the Engineering Vehicle.
4. Refer to the user manual for specific instructions on the functions and capabilities of the remote control.

Maintenance and Care

1. Keep the Engineering Vehicle and the remote control clean and free from dust or debris.
2. Avoid exposing the equipment to extreme temperatures or moisture.
3. Store the equipment in a dry and safe place when not in use.
4. Regularly inspect the batteries in the remote control and replace them when necessary.

Specifications

• Product: Engineering Vehicle
• Remote Control Battery: 2 pcs AA batteries
• FCC Compliance: Complies with Part 15 of FCC Rules

Engineering Vehicle Brief Description

Remote Control Instructions

Battery Installation Instructions

1. Press here to open the battery cover.
2. Install 3AA battery and close the cover.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
The device has be enevaluated to meet general RF exposure requirement.The device can be used in portable exposure condition without restriction. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.\

Frequently Asked Questions

How long do the batteries last in the remote control?

The battery life can vary depending on usage, but on average, the batteries should last for several hours of continuous operation before needing replacement.

Can I use rechargeable batteries with the remote control?

Yes, you can use rechargeable AA batteries with the remote control. Ensure they are fully charged before use.

What is the range of the remote control?

The range of the remote control may vary, but it typically works within a range of 30 to 50 meters.

Can I use the Engineering Vehicle outdoors?

Yes, the Engineering Vehicle can be used outdoors. However, avoid exposing it to extreme weather conditions such as heavy rain or excessive heat to prevent damage.

How do I clean the Engineering Vehicle and the remote control?

Use a soft, dry cloth to clean the surfaces of the equipment. Avoid using harsh chemicals or abrasive materials that could damage the product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>