Goldsea 97060 Cordless Chain Saw User Manual
- June 15, 2024
- Goldsea
Table of Contents
Goldsea 97060 Cordless Chain Saw
Please read the instructions carefully before first use. Please ensure you follow the safety Check Procedure before every use If you have any questions about your Goldsea product, please do not hesitate to contact us.
Product Enquiries
Home page
https://goldseatool.com
Soziale Medien
Youtube:goldsea_tool
Instagram:goldsea_tool
It may take some time to respond. Please know in advance. When inquiring, please have a receipt or delivery statement for the product or something that shows the information at the time of purchase.
Safety Check
Please follow the safety check before every use.
-
Please check if the chain is loose as shown in the below picture, if loose, please follow the instructions steps 1-4. Key
Warning: A loose chain will derail, and can lead to rapid wear of the chain and the guide plate. -
If you have adjusted the chain, please make sure the knob is tightened Loosen the outer knob (the knob is divided into two levels, the outer knob secures the side cover and the inner knob adjusts the tightness of the chain).
-
Turn the inner knob to adjust the chain tightness as shown.
Key Parts for Functionality
Add 2/3 lubricating oil before using the chainsaw, and press the oil pump button twice to lubricate the chain normally.
How To Assemble
How to remove the chain
Loosen the knob and remove the side cover. Remove the side cover and guide
plate as shown in the picture below.
How To Install The Chain
First, load the chain into the guide plate. The middle guide tooth fits easily
into the guide plate slot. Attach the guide plate to the chainsaw as shown in
the diagram and loop the chain around the gear. (Please note: each projection
of the chain should correspond with the recessed part of the gear)
Please note: When installing the side cover, align the removable nut with a small hole in the guide plate. As shown in the picture below.
Put on the side cover and screw on the knob.
(Note: the knob does not need to be tightened)
Adjust the tension of the chain by turning the knob clockwise as shown in the diagram. Adjustment is complete when the distance between the chain pulled outwards and the guide plate is 0.3 cm. Finally, tighten the knob securely and you are now ready to cut.
Frequently Asked Questions and Answers
